HD6417144F50V Renesas Electronics America, HD6417144F50V Datasheet - Page 602

• Manufacturer Part Number: HD6417144F50V
• Description: IC SUPERH MCU ROMLESS 112QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7144r

Specifications of HD6417144F50V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Type: ROMless
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 112-QFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)EDK7145 - DEV EVALUATION KIT SH7145
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

15. A/D Converter
15.7
15.7.1
Operation of the A/D converter can be disabled or enabled using the module standby control
register. The initial setting is for operation of the A/D converter to be halted. Register access is
enabled by clearing module standby mode. For details, refer to section 24, Power-Down Modes.
15.7.2
This LSI's analog input is designed such that conversion accuracy is guaranteed for an input signal
for which the signal source impedance is 1 kΩ or less. This specification is provided to enable the
A/D converter's sample-and-hold circuit input capacitance to be charged within the sampling time;
if the sensor output impedance exceeds 1 kΩ, charging may be insufficient and it may not be
possible to guarantee A/D conversion accuracy. With a large capacitance provided externally for
A/D conversion in single mode, the input impedance will essentially comprise only the internal
input resistance of 10 kΩ, and the signal source impedance is ignored. However, as a low-pass
filter effect is obtained in this case, it may not be possible to follow a high speed switching analog
signal (e.g., 5 mV/μs or greater) (see figure 15.6). When converting a high-speed analog signal or
performing conversion in scan mode, a low-impedance buffer should be inserted.
15.7.3
Adding capacitance results in coupling with GND, and therefore noise in GND may adversely
affect absolute accuracy. Be sure to make the connection to an electrically stable GND such as
AVss.
Care is also required to insure that filter circuits do not interfere in the accuracy by the digital
signals on the printed circuit board (i.e, acting as antennas).
Rev.4.00 Mar. 27, 2008 Page 556 of 882
REJ09B0108-0400
Usage Notes
Module Standby Mode Setting
Permissible Signal Source Impedance
Influences on Absolute Accuracy
Sensor input
Figure 15.6 Example of Analog Input Circuit
Sensor output
impedance of
up to 1 kΩ
Low-pass
filter
C = 0.1 μF
This LSI
C
20 pF
in
=
A/D converter
equivalent circuit
10 kΩ
20 pF