s3c4510b Samsung Semiconductor, Inc., s3c4510b Datasheet - Page 177

• Manufacturer Part Number: s3c4510b
• Description: 16/32-bit Risc Microcontroller
• Manufacturer: Samsung Semiconductor, Inc.

S3C4510B
ROM/SRAM/FLASH CONTROL REGISTERS (ROMCON)
The System Manager has six control registers for ROM, SRAM, and flash memory (see Table 4-21). These
registers correspond to the up to six ROM/SRAM/Flash banks that are supported by S3C4510B.
For ROM/SRAM/Flash bank 0, the external data bus width is determined by the signal at the B0SIZE[1:0] pins:
You can determine the start address of a special register's bank by the value of the corresponding "special
register bank base pointer". The control register's physical address is always the sum of the register's bank base
pointer plus the register's offset address.(For example, base pointer is 0x3ff0000 and ROMCON0’s offset is
0x3014. Then ROMCON0’s physical address becomes 0x3ff3014.)
ROMCON0
ROMCON1
ROMCON2
ROMCON3
ROMCON4
ROMCON5
When B0SIZE[1:0] = "01", the external bus width for ROM/SRAM/Flash bank 0 is 8 bits.
When B0SIZE[1:0] = "10", the external bus width for ROM/SRAM/Flash bank 0 is 16 bits.
When B0SIZE[1:0] = "11", the external bus width for ROM/SRAM/Flash bank 0 is 32 bits.
If you attach SRAM to a ROM/SRAM/Flash bank, you must set the page mode configuration bits,
ROMCONn[1:0], in the corresponding control register to "00" (normal ROM).
Registers
0x301C
0x3014
0x3018
0x3020
0x3024
0x3028
Table 4-21. ROM/SRAM/Flash Control Register Description
Offset
R/W
R/W
R/W
R/W
R/W
R/W
R/W
ROM/SRAM/Flash bank 0 control register
ROM/SRAM/Flash bank 1 control register
ROM/SRAM/Flash bank 2 control register
ROM/SRAM/Flash bank 3 control register
ROM/SRAM/Flash bank 4 control register
ROM/SRAM/Flash bank 5 control register
NOTE
Description
SYSTEM MANAGER
Reset Value
0x20000060
0x00000060
0x00000060
0x00000060
0x00000060
0x00000060
4-35