h8s-2161b Renesas Electronics Corporation., h8s-2161b Datasheet - Page 143

• Manufacturer Part Number: h8s-2161b
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 5 Interrupt Controller
Section 5 Interrupt Controller
5.1
Features
Two interrupt control modes
Any of two interrupt control modes can be set by means of the INTM1 and INTM0 bits in the
system control register (SYSCR).
Priorities settable with ICR
An interrupt control register (ICR) is provided for setting interrupt priorities. Three priority
levels can be set for each module for all interrupts except NMI and address break.
Independent vector addresses
All interrupt sources are assigned independent vector addresses, making it unnecessary for the
source to be identified in the interrupt handling routine.
Thirty-one external interrupts
NMI is the highest-priority interrupt, and is accepted at all times. Rising edge or falling edge
detection can be selected for NMI. Falling-edge, rising-edge, or both-edge detection, or level
sensing, can be selected for IRQ7 to IRQ0. The IRQ6 interrupt is shared by the interrupt from
the IRQ6 pin and eight external interrupt inputs (KIN7 to KIN0), and the IRQ7 interrupt is
shared by the interrupt from the IRQ7 pin and sixteen external interrupt inputs (KIN15 to
KIN8 and WUE7 to WUE0). KIN15 to KIN0 and WUE7 to WUE0 can be masked
individually by the user program.
DTC control
The DTC can be activated by an interrupt request.
Rev. 3.00 Mar 21, 2006 page 89 of 788
REJ09B0300-0300