h8s-2161b Renesas Electronics Corporation., h8s-2161b Datasheet - Page 758

• Manufacturer Part Number: h8s-2161b
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 27 Electrical Characteristics
Notes: 1. Do not leave the AV
Rev. 3.00 Mar 21, 2006 page 704 of 788
REJ09B0300-0300
Item
Output low
voltage
2. P67 to P60 include peripheral module inputs multiplexed on those pins.
3. IRQ2 includes the ADTRG signal multiplexed on that pin.
4. P52/SCK0/SCL0, P97/SDA0, P86/SCK1/SCL1, P42/SCK2/SDA1, and port G are
5. When IICS = 0, ICE = 0, and KBIOE = 0. Low-level output when the bus drive function
6. The upper limit of the port 6 applied voltage is V
7. The upper limit of the port A applied voltage is V
8. The port A characteristics depend on V
9. For flash memory programming/erasure, the applicable range is V
Even if the A/D converter and D/A converter are not used, apply a value in the range 2.0
When the SCL0, SDA0, SCL1, or SDA1 (ICE = 1) pin is used as an output, it is NMOS
P52/SCK0, P97, P86/SCK1, P42/SCK2 (ICE = 0), and port G high levels are driven by
An external pull-up resistor is necessary to provide high-level output from SCK0, SCK1,
converter are not used.
V to 3.6 V to AV
method. Ensure that AV
NMOS push-pull outputs.
open-drain output. Therefore, an external pull-up resistor must be connected in order to
output high level.
NMOS.
and SCK2.
is selected is determined separately.
selected, and the lower of V
When a pin is in output mode, the output voltage is equivalent to the applied voltage.
selected, and the lower of V
When a pin is in output mode, the output voltage is equivalent to the applied voltage.
on V
All output pins
(except RESO) *
(Ports C to G are
added in the
H8S/2160B and
H8S/2161B.)
Ports 1 to 3
RESO
CC
.
CC
and AV
5
cc
, AV
ref
ref
ref
Symbol Min
V
pins by connection to the power supply (V
AV
OL
, and AV
CC
CC
B + 0.3 V and AV
+ 0.3 V and AV
CC
.
ss
—
—
—
pins open even if the A/D converter and D/A
CC
B, and the other pins characteristics depend
CC
CC
+ 0.3 V when CIN input is selected.
CC
CC
Typ
—
—
—
+ 0.3 V when CIN input is selected.
B + 0.3 V when CIN input is not
+ 0.3 V when CIN input is not
Max
0.4
1.0
0.4
CC
Unit
V
V
V
= 3.0 V to 3.6 V.
CC
), or some other
Test
Conditions
I
I
I
OL
OL
OL
= 1.6 mA
= 5 mA
= 1.6 mA