h8s-2161b Renesas Electronics Corporation., h8s-2161b Datasheet - Page 707

• Manufacturer Part Number: h8s-2161b
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Figure 25.4 shows an example of hardware standby mode timing.
25.7
The CPU makes a transition to watch mode when the SLEEP instruction is executed in high-speed
mode or subactive mode with the SSBY bit in SBYCR set to 1, the DTON bit in LPWRCR
cleared to 0, and the PSS bit in TCSR (WDT_1) set to 1.
In watch mode, the CPU is stopped and peripheral modules other than WDT_1 are also stopped.
The contents of the CPU’s internal registers, several on-chip peripheral module registers, and on-
chip RAM data are retained and the I/O ports retain their values before transition as long as the
prescribed voltage is supplied.
Watch mode is exited by an interrupt (WOVI1, NMI, IRQ0 to IRQ2, IRQ6, or IRQ7), RES pin
input, or STBY pin input.
When an interrupt occurs, watch mode is exited and a transition is made to high-speed mode or
medium-speed mode when the LSON bit in LPWRCR cleared to 0 or to subactive mode when the
LSON bit is set to 1. When a transition is made to high-speed mode, a stable clock is supplied to
the entire LSI and interrupt exception handling starts after the time set in the STS2 to STS0 bits in
SBYCR has elapsed. In the case of an IRQ0 to IRQ2, IRQ6, or IRQ7 interrupt, watch mode is not
exited if the corresponding enable bit has been cleared to 0. In the case of interrupts from the on-
chip peripheral modules, watch mode is not exited if the interrupt enable register has been set to
disable the reception of that interrupt, or the interrupt is masked by the CPU.
Oscillator
RES
STBY
Watch Mode
Figure 25.4 Hardware Standby Mode Timing
Rev. 3.00 Mar 21, 2006 page 653 of 788
Oscillation
stabilization
time
Section 25 Power-Down Modes
REJ09B0300-0300
exception
handling
Reset