h8s-2161b Renesas Electronics Corporation., h8s-2161b Datasheet - Page 652

• Manufacturer Part Number: h8s-2161b
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 21 A/D Converter
21.7
21.7.1
This LSI’s analog input (3-V version) is designed so that the conversion accuracy is guaranteed
for an input signal for which the signal source impedance is 5 k or less. This specification is
provided to enable the A/D converter’s sample-and-hold circuit input capacitance to be charged
within the sampling time; if the sensor output impedance exceeds 5 k , charging may be
insufficient and it may not be possible to guarantee the A/D conversion accuracy. However, if a
large capacitance is provided externally in single mode, the input load will essentially comprise
only the internal input resistance of 10 k , and the signal source impedance is ignored. However,
since a low-pass filter effect is obtained in this case, it may not be possible to follow an analog
signal with a large differential coefficient (e.g., voltage fluctuation ratio of 5 mV/µs or greater)
(see figure 21.7). When converting a high-speed analog signal or converting in scan mode, a low-
impedance buffer should be inserted. For details on the 5-V version, refer to section 28, Electrical
Characteristics.
21.7.2
Adding capacitance results in coupling with ground, and therefore noise in ground may adversely
affect the absolute accuracy. Be sure to make the connection to an electrically stable ground such
as AVss.
Care is also required to insure that filter circuits do not communicate with digital signals on the
mounting board, so acting as antennas.
Rev. 3.00 Mar 21, 2006 page 598 of 788
REJ09B0300-0300
Usage Notes
Permissible Signal Source Impedance
Influences on Absolute Accuracy
Sensor input
Sensor output
impedance
to 5 k
Low-pass
filter
C to 0.1 µF
Figure 21.7 Example of Analog Input Circuit
This LSI
C
15 pF
in
=
A/D converter equivalent circuit
10 k
20 pF