HD6417144 RENESAS [Renesas Technology Corp], HD6417144 Datasheet - Page 202

• Manufacturer Part Number: HD6417144
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family/SH7144 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

9. Bus State Controller (BSC)
9.7
When a read from a slow device is completed, data buffers may not go off in time, causing conflict
with the next access data. If there is a data conflict during memory access, the problem can be
solved by inserting a wait in the access cycle.
To enable detection of bus cycle starts, waits can be inserted between access cycles during
continuous accesses of the same CS space by negating the CSn signal once.
9.7.1
Wait cycles are inserted in the following cases so that the number of idle cycles specified with the
IW31 to IW00 bits are inserted:
• The write cycle to the same CS space continues after the cycle read
• The continuous access is made to the different CS space after the read access
If there are idle cycles between the access cycles, the number of wait cycles is inserted that is
obtained by subtracting the existing idle cycles from the number of idle cycles specified.
Figure 9.7 shows the example of idle cycle insertion. In this example, when one idle cycle
insertion is specified between CSn space cycles, the specified one idle cycle is inserted when the
write access is performed to the CSm space immediately after the read cycle of the CSn space.
Rev.4.00 Mar. 27, 2008 Page 158 of 882
REJ09B0108-0400
Waits between Access Cycles
Prevention of Data Bus Conflicts