AT90CAN32 Automotive Atmel Corporation, AT90CAN32 Automotive Datasheet - Page 170

• Manufacturer Part Number: AT90CAN32 Automotive
• Manufacturer: Atmel Corporation

Specifications of AT90CAN32 Automotive

• Flash (kbytes): 32 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 53
• Ext Interrupts: 8
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 2
• Can: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 2
• Eeprom (bytes): 1024
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 125
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 4
• Output Compare Channels: 8
• Input Capture Channels: 2
• Pwm Channels: 7
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

170
AT90CAN32/64/128
DDR_SPI in the examples must be replaced by the actual Data Direction Register controlling the
SPI pins. DD_MOSI, DD_MISO and DD_SCK must be replaced by the actual data direction bits
for these pins. E.g. if MOSI is placed on pin PB2, replace DD_MOSI with DDB2 and DDR_SPI
with DDRB.
Note:
Assembly Code Example
C Code Example
SPI_MasterInit:
SPI_MasterTransmit:
Wait_Transmit:
void SPI_MasterInit(void)
{
}
void SPI_MasterTransmit(char cData)
{
}
; Set MOSI and SCK output, all others input
ldi
out
; Enable SPI, Master, set clock rate fck/16
ldi
out
ret
; Start transmission of data (r16)
out
; Wait for transmission complete
in
sbrs
rjmp
ret
/* Set MOSI and SCK output, all others input */
DDR_SPI = (1<<DD_MOSI)|(1<<DD_SCK);
/* Enable SPI, Master, set clock rate fck/16 */
SPCR = (1<<SPE)|(1<<MSTR)|(1<<SPR0);
/* Start transmission */
SPDR = cData;
/* Wait for transmission complete */
while(!(SPSR & (1<<SPIF)));
1. The example code assumes that the part specific header file is included.
r17,(1<<DD_MOSI)|(1<<DD_SCK)
DDR_SPI,r17
r17,(1<<SPE)|(1<<MSTR)|(1<<SPR0)
SPCR,r17
SPDR,r16
r17,SPSR
r17,SPIF
Wait_Transmit
(1)
(1)
7682C–AUTO–04/08