cx28394 Conexant Systems, Inc., cx28394 Datasheet - Page 144

• Manufacturer Part Number: cx28394
• Description: Quad/x16/octal-t1/e1/j1 Framers
• Manufacturer: Conexant Systems, Inc.

3.0 Registers
3.5 Interrupt Status Registers
All events in ISR0 are from rising edge sources. Each event is latched active high and held until the processor
read clears ISR0. Each event triggers an interrupt if the corresponding IER0 bit is enabled [addr 013].
BSLIP
PSYNC
TCERR
TSERR
TMERR
TFERR
3-22
00B—Pattern Interrupt Status (ISR0)
—
7
Online Framer Bit Slip—Active high, indicates receive online framer adjusted receive frame
sync by 1 bit. When BSLIP occurs, the apparent FAS error is not reported elsewhere (not to
FERR count, RLOF circuit, or SEF circuit). Applicable only to receive framer modes with
BSLIP enabled (see
Receive PRBS Test Pattern Sync—Forced to inactive (low) status when the processor requests
RESEED [addr 041] of the PRBS sync detector and remains low while the detector searches
for test pattern sync. PRBS bit errors [BERR; addr 058, 059] are not counted while PSYNC is
low. PSYNC remains low for a minimum of 128 bits following RESEED and for as long as the
received bit error ratio (BER) exceeds 10E-2. PSYNC is latched active (high) and the PRBS
sync detector stops searching when no bit errors are found for a period of 96 bits. The sync
detector remains disabled until the processor requests another RESEED. Therefore, any range
of BER can be measured after initial pattern sync. The processor must determine criteria for
loss of pattern sync based on its accumulation of bit errors over the desired time interval.
Transmit CRC Error—Reports occurrences of CRC-6 or CRC-4 errors detected on TPCMI
data according to the selected T1/E1 mode.
Transmit CAS Error—Reports occurrences of MAS pattern errors detected on TPCMI data if
CAS transmit framer mode is selected.
Transmit Multiframe Error—Reports occurrences of Fs or MFAS errors detected on TPCMI
data according to the selected transmit framer mode.
Transmit Frame Error—Reports occurrences of Ft, FPS, or FAS errors detected on TPCMI
data according to the selected transmit framer mode.
—
0 = no error
1 = frame bit slip
0 = no sync
1 = PRBS test pattern sync
0 = no error
1 = CRC error
0 = no error
1 = CAS error
0 = no error
1 = transmit multiframe error
0 = no error
1 = transmit frame error
6
BSLIP
5
Table
3-5).
PSYNC
4
Conexant
TCERR
3
TSERR
2
Quad/x16/Octal—T1/E1/J1 Framers
CX28394/28395/28398
TMERR
1
TFERR
100054E
0