MC68HC908JG16FA MOTOROLA [Motorola, Inc], MC68HC908JG16FA Datasheet - Page 176

• Manufacturer Part Number: MC68HC908JG16FA
• Description: Microcontrollers
• Manufacturer: MOTOROLA [Motorola, Inc]

Universal Serial Bus Module (USB)
11.7.2.1 Output Driver Characteristics
11.7.2.2 Low Speed (1.5 Mbps) Driver Characteristics
Technical Data
176
The USB transceiver uses a differential output driver to drive the USB
data signal onto the USB cable. The static output swing of the driver in
its low state is below the V
its high state is above the V
output swings between the differential high and low state are well
balanced to minimize signal skew. Slew rate control on the driver is used
to minimize the radiated noise and cross talk. The driver’s outputs
support 3-state operation to achieve bidirectional half duplex operation.
The driver can tolerate a voltage on the signal pins of –1.0V to 5.5V with
respect to local ground reference without damage.
The rise and fall time of the signals on this cable are greater than 75ns
and less than 300ns. The edges are matched to within 20% to minimize
RFI emissions and signal skew.
USB data transmission is done with differential signals. A differential
input receiver is used to accept the USB data signal. A differential 1 on
the bus is represented by D+ being at least 200mV more positive than
D– as seen at the receiver, and a differential 0 is represented by D–
being at least 200mV more positive than D+ as seen at the receiver. The
signal cross over point must be between 1.3V and 2.0V.
V
V
Freescale Semiconductor, Inc.
SE
SE
(max)
(min.)
For More Information On This Product,
V
SS
Universal Serial Bus Module (USB)
Go to: www.freescale.com
Figure 11-11. Receiver Characteristics
(1.5 Mb/s)
ONE BIT
TIME
OL
OH
of 0.3V with a 1.5k
of 2.8V with a 15k load to ground. The
REFLECTIONS AND RINGING
LEVELS WITH MINIMAL
PASS OUTPUT SPEC
SIGNAL PINS
MC68HC908JG16
load to 3.6V and in
MOTOROLA
—
Rev. 1.0