MC68HC908JG16FA MOTOROLA [Motorola, Inc], MC68HC908JG16FA Datasheet - Page 62

• Manufacturer Part Number: MC68HC908JG16FA
• Description: Microcontrollers
• Manufacturer: MOTOROLA [Motorola, Inc]

FLASH Memory
4.7 FLASH Program Operation
Technical Data
62
NOTE:
Programming of the FLASH memory is done on a row basis. A row
consists of 64 consecutive bytes starting from addresses $XX00,
$XX40, $XX80 or $XXC0. The procedure for programming a row of the
FLASH memory is outlined below:
This program sequence is repeated throughout the memory until all data
is programmed.
Programming and erasing of FLASH locations cannot be performed by
executing code from the FLASH memory; the code must be executed
from RAM. While these operations must be performed in the order as
shown, but other unrelated operations may occur between the steps. Do
not exceed t
Characteristics.
Figure 4-3
FLASH memory.
10. Wait for time, t
11. Clear the HVEN bit.
12. After time, t
1. Set the PGM bit. This configures the memory for program
2. Write any data to any FLASH address within the address range of
3. Wait for a time, t
4. Set the HVEN bit.
5. Wait for a time, t
6. Write data to the byte being programmed.
7. Wait for time, t
8. Repeat steps 6 and 7 until all the bytes within the row are
9. Clear the PGM bit.
Freescale Semiconductor, Inc.
For More Information On This Product,
operation and enables the latching of address and data for
programming.
the row to be programmed.
programmed.
again.
shows a flowchart representation for programming the
Prog
Go to: www.freescale.com
maximum. See
FLASH Memory
rcv
Prog
nvh
(1 s), the memory can be accessed in read mode
nvs
pgs
(5 s).
(30 s).
(5 s).
(10 s).
20.14 FLASH Memory
MC68HC908JG16
MOTOROLA
—
Rev. 1.0