LPC1114FHN33/203,5 NXP Semiconductors, LPC1114FHN33/203,5 Datasheet - Page 421

• Manufacturer Part Number: LPC1114FHN33/203,5
• Description: ARM Microcontrollers - MCU Cortex-M0 32 kB Fl 8 kB SRAM
• Manufacturer: NXP Semiconductors

Specifications of LPC1114FHN33/203,5

• Rohs: yes
• Core: ARM Cortex M0
• Processor Series: LPC1114
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 32 KB
• Data Ram Size: 8 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.8 V to 3.6 V
• Operating Temperature Range: - 65 C to + 150 C
• Package / Case: HVQFN-33
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 260

NXP Semiconductors
UM10398
User manual
26.5.10 Blank check sector(s) <sector number> <end sector number> (UART
26.5.11 Read Part Identification number (UART ISP)
26.5.9 Erase sector(s) <start sector number> <end sector number> (UART
ISP)
Table 383. UART ISP Erase sector command
ISP)
Table 384. UART ISP Blank check sector command
Table 385. UART ISP Read Part Identification command
Command
Input
Return Code CMD_SUCCESS |
Description
Example
Command
Input
Return Code CMD_SUCCESS |
Description
Example
Command
Input
Return Code CMD_SUCCESS followed by part identification number in ASCII (see
Description
"E 2 3<CR><LF>" erases the flash sectors 2 and 3.
"I 2 3<CR><LF>" blank checks the flash sectors 2 and 3.
None.
E
Start Sector Number
End Sector Number: Should be greater than or equal to start sector number.
BUSY |
INVALID_SECTOR |
SECTOR_NOT_PREPARED_FOR_WRITE_OPERATION |
CMD_LOCKED |
PARAM_ERROR |
CODE_READ_PROTECTION_ENABLED
This command is used to erase one or more sector(s) of on-chip flash memory. The
boot block can not be erased using this command. This command only allows
erasure of all user sectors when the code read protection is enabled.
I
Start Sector Number:
End Sector Number: Should be greater than or equal to start sector number.
SECTOR_NOT_BLANK (followed by <Offset of the first non blank word location>
<Contents of non blank word location>) |
INVALID_SECTOR |
PARAM_ERROR
This command is used to blank check one or more sectors of on-chip flash memory.
Blank check on sector 0 always fails as first 64 bytes are re-mapped to flash
boot block.
When CRP is enabled, the blank check command returns 0 for the offset and value
of sectors which are not blank. Blank sectors are correctly reported irrespective of
the CRP setting.
J
This command is used to read the part identification number.
All information provided in this document is subject to legal disclaimers.
Rev. 12 — 24 September 2012
Chapter 26: LPC111x/LPC11Cxx Flash programming firmware
UM10398
© NXP B.V. 2012. All rights reserved.
Table
421 of 538
386).