LPC1114FHN33/203,5 NXP Semiconductors, LPC1114FHN33/203,5 Datasheet - Page 424

• Manufacturer Part Number: LPC1114FHN33/203,5
• Description: ARM Microcontrollers - MCU Cortex-M0 32 kB Fl 8 kB SRAM
• Manufacturer: NXP Semiconductors

Specifications of LPC1114FHN33/203,5

• Rohs: yes
• Core: ARM Cortex M0
• Processor Series: LPC1114
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 32 KB
• Data Ram Size: 8 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.8 V to 3.6 V
• Operating Temperature Range: - 65 C to + 150 C
• Package / Case: HVQFN-33
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 260

NXP Semiconductors
UM10398
User manual
26.5.14 ReadUID (UART ISP)
26.5.15 UART ISP Return Codes
Table 389. UART ISP ReadUID command
Table 390. UART ISP Return Codes Summary
Command
Input
Return Code CMD_SUCCESS followed by four 32-bit words of E-sort test information in ASCII
Description
Return
Code
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Mnemonic
CMD_SUCCESS
INVALID_COMMAND
SRC_ADDR_ERROR
DST_ADDR_ERROR
SRC_ADDR_NOT_MAPPED
DST_ADDR_NOT_MAPPED
COUNT_ERROR
INVALID_SECTOR
SECTOR_NOT_BLANK
SECTOR_NOT_PREPARED_FOR_
WRITE_OPERATION
COMPARE_ERROR
BUSY
PARAM_ERROR
ADDR_ERROR
ADDR_NOT_MAPPED
CMD_LOCKED
INVALID_CODE
INVALID_BAUD_RATE
INVALID_STOP_BIT
CODE_READ_PROTECTION_
ENABLED
None
N
format. The word sent at the lowest address is sent first.
This command is used to read the unique ID.
All information provided in this document is subject to legal disclaimers.
Rev. 12 — 24 September 2012
Chapter 26: LPC111x/LPC11Cxx Flash programming firmware
Description
Command is executed successfully. Sent by ISP
handler only when command given by the host has
been completely and successfully executed.
Invalid command.
Source address is not on word boundary.
Destination address is not on a correct boundary.
Source address is not mapped in the memory map.
Count value is taken in to consideration where
applicable.
Destination address is not mapped in the memory
map. Count value is taken in to consideration
where applicable.
Byte count is not multiple of 4 or is not a permitted
value.
Sector number is invalid or end sector number is
greater than start sector number.
Sector is not blank.
Command to prepare sector for write operation
was not executed.
Source and destination data not equal.
Flash programming hardware interface is busy.
Insufficient number of parameters or invalid
parameter.
Address is not on word boundary.
Address is not mapped in the memory map. Count
value is taken in to consideration where applicable.
Command is locked.
Unlock code is invalid.
Invalid baud rate setting.
Invalid stop bit setting.
Code read protection enabled.
UM10398
© NXP B.V. 2012. All rights reserved.
424 of 538