R0K572011S000BE Renesas Electronics America, R0K572011S000BE Datasheet - Page 869

• Manufacturer Part Number: R0K572011S000BE
• Description: KIT STARTER FOR SH7201
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572011S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: SH7201
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

SH7201 Group
Bit 8 - Mailbox Empty Interrupt Flag (IRR8): This bit is set when one of the messages set for
transmission has been successfully sent (corresponding TXACK flag is set) or has been
successfully aborted (corresponding ABACK flag is set). The related TXPR is also cleared and
this mailbox is now ready to accept a new message data for the next transmission. In effect, this
bit is set by an OR'ed signal of the TXACK and ABACK bits not masked by the corresponding
MBIMR flag. Therefore, this bit is automatically cleared when all the TXACK and ABACK bits
are cleared. It is also cleared by writing a '1' to all the correspondent bit position in MBIMR.
Writing to this bit position has no effect.
Bit 7 - Overload Frame (IRR7): Flag indicating that the RCAN-ET has detected a condition that
should initiate the transmission of an overload frame. Note that on the condition of transmission
being prevented, such as listen only mode, an Overload Frame will NOT be transmitted, but IRR7
will still be set. IRR7 remains asserted until reset by writing a '1' to this bit position - writing a '0'
has no effect.
R01UH0026EJ0300 Rev. 3.00
Sep 24, 2010
Bit 8: IRR8
0
1
Bit 7: IRR7
0
1
Description
Messages set for transmission or transmission cancellation request NOT
progressed. (Initial value)
[Clearing Condition] All the TXACK and ABACK bits are cleared/setting
MBIMR for all TXACK and ABACK set
Message has been transmitted or aborted, and new message can be stored
[Setting condition]
When one of the TXPR bits is cleared by completion of transmission or
completion of transmission abort, i.e., when a TXACK or ABACK bit is set
(if MBIMR = 0).
Description
[Clearing condition] Writing 1 (Initial value)
[Setting conditions] Overload condition detected
Section 19 Controller Area Network (RCAN-ET)
Page 841 of 1190