LFEBS12UB Freescale Semiconductor, LFEBS12UB Datasheet - Page 352

• Manufacturer Part Number: LFEBS12UB
• Description: KIT STUDENT LEARNING S12 DG128
• Manufacturer: Freescale Semiconductor

Specifications of LFEBS12UB

• Architecture: 8/16-bit
• Code Gen Tools Included: Code Warrior
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12D
• Kit Contents: HCS12 DG128 Learning Kit
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Chapter 9 Security (S12XE9SECV2)
9.1.4.2
Special single chip mode means BDM is active after reset. The availability of BDM firmware commands
depends on the security state of the device. The BDM secure firmware first performs a blank check of both
the Flash memory and the EEPROM. If the blank check succeeds, security will be temporarily turned off
and the state of the security bits in the appropriate Flash memory location can be changed If the blank
check fails, security will remain active, only the BDM hardware commands will be enabled, and the
accessible memory space is restricted to the peripheral register area. This will allow the BDM to be used
to erase the EEPROM and Flash memory without giving access to their contents. After erasing both Flash
memory and EEPROM, another reset into special single chip mode will cause the blank check to succeed
and the options/security byte can be programmed to “unsecured” state via BDM.
While the BDM is executing the blank check, the BDM interface is completely blocked, which means that
all BDM commands are temporarily blocked.
9.1.4.3
9.1.5
Unsecuring the microcontroller can be done by three different methods:
9.1.5.1
In normal modes (single chip and expanded), security can be temporarily disabled using the backdoor key
access method. This method requires that:
352
Because of an order from the United States International Trade Commission, BGA-packaged product lines and partnumbers
indicated here currently are not available from Freescale for import or sale in the United States prior to September 2010
•
•
•
•
•
•
•
•
•
•
1. Backdoor key access
2. Reprogramming the security bits
3. Complete memory erase (special modes)
•
BDM firmware commands are disabled.
BDM hardware commands are restricted to the register space.
Execution of Flash and EEPROM commands is restricted. Please refer to the NVM block guide for
details.
Tracing code execution using the DBG module is disabled.
Debugging XGATE code (breakpoints, single-stepping) is disabled.
BDM operation is completely disabled.
Internal Flash memory and EEPROM are disabled.
Execution of Flash and EEPROM commands is restricted. Please refer to the FTM block guide for
details.
Tracing code execution using the DBG module is disabled.
Debugging XGATE code (breakpoints, single-stepping) is disabled
The backdoor key at 0xFF00–0xFF07 (= global addresses 0x7F_FF00–0x7F_FF07) has been
programmed to a valid value.
Unsecuring the Microcontroller
Special Single Chip Mode (SS)
Expanded Modes (NX, ES, EX, and ST)
Unsecuring the MCU Using the Backdoor Key Access
MC9S12XE-Family Reference Manual , Rev. 1.23
Freescale Semiconductor