HD6433044 Hitachi Semiconductor, HD6433044 Datasheet - Page 172

• Manufacturer Part Number: HD6433044
• Description: (HD64 Series) Hitachi Single-Chip Microcomputer
• Manufacturer: Hitachi Semiconductor

Table 7-4 Area 3 Settings, DRAM Access Cycles, and Refresh Cycles
Area 3 Settings
2-state-access area
(AST3 = 0)
3-state-access area
(AST3 = 1)
To insert refresh cycles, set the RCYCE bit to 1 in RFSHCR. Figure 7-3 shows the state
transitions for execution of refresh cycles.
When the first refresh request occurs after exit from the reset state or standby mode, the refresh
controller does not execute a refresh cycle, but goes into the refresh request pending state. Note
this point when using a DRAM that requires a refresh cycle for initialization.
When a refresh request occurs in the refresh request pending state, the refresh controller acquires
the bus right, then executes a refresh cycle. If another refresh request occurs during execution of
the refresh cycle, it is ignored.
Note:
Refresh
request *
Refresh
request *
*
A refresh request is ignored if it occurs while the refresh controller is requesting the
bus right or executing a refresh cycle.
Figure 7-3 State Transitions for Refresh Cycle Execution
Read/Write Cycle by CPU or DMAC
• 3 states
• Wait states cannot be inserted
• 3 states
• Wait states can be inserted
Exit from reset or standby mode
Refresh request pending state
Executing refresh cycle
Requesting bus right
158
Refresh request
Refresh request
Bus granted
Refresh Cycle
• 3 states
• Wait states cannot be inserted
• 3 states
• Wait states can be inserted
End of refresh
cycle
*