PI7C8152BMAE Pericom Semiconductor, PI7C8152BMAE Datasheet - Page 61

• Manufacturer Part Number: PI7C8152BMAE
• Description: IC PCI-PCI BRIDGE 2PORT 160-MQFP
• Manufacturer: Pericom Semiconductor

Specifications of PI7C8152BMAE

• Applications: *
• Interface: *
• Voltage - Supply: *
• Package / Case: 160-MQFP, 160-PQFP
• Mounting Type: Surface Mount
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Operating Supply Voltage: 3 V to 3.6 V
• Supply Current (max): 246 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PI7C8152A & PI7C8152B
2-PORT PCI-TO-PCI BRIDGE
ADVANCE INFORMATION
group and a low priority group. The low priority group as a whole represents one entry in
the high priority group; that is, if the high priority group consists of n masters, then in at
least every n+1 transactions the highest priority is assigned to the low priority group.
Priority rotates evenly among the low priority group. Therefore, members of the high
priority group can be serviced n transactions out of n+1, while one member of the low
priority group is serviced once every n+1 transactions. Figure 8-1 shows an example of an
internal arbiter where three masters, including PI7C8152x, are in the high priority group,
and two masters are in the low priority group. Using this example, if all requests are always
asserted, the highest priority rotates among the masters in the following fashion (high
priority members are given in italics, low priority members, in boldface type): B, m0, m1,
m2, B, m0, m1, m3, B, m0, m1, m4.
Figure 8-1 SECONDARY ARBITER EXAMPLE
lpg
m1
m2
B
m0
m3
m4
Each bus master, including PI7C8152x, can be configured to be in either the low priority
group or the high priority group by setting the corresponding priority bit in the arbiter-
control register. The arbiter-control register is located at offset 40h. Each master has a
corresponding bit. If the bit is set to 1, the master is assigned to the high priority group. If
the bit is set to 0, the master is assigned to the low priority group. If all the masters are
assigned to one group, the algorithm defaults to a straight rotating priority among all the
masters. After reset, all external masters are assigned to the low priority group, and
PI7C8152x is assigned to the high priority group. PI7C8152x receives highest priority on
the target bus every other transaction and priority rotates evenly among the other masters.
Priorities are re-evaluated every time S_FRAME_L is asserted at the start of each new
transaction on the secondary PCI bus. From this point until the time that the next
transaction starts, the arbiter asserts the grant signal corresponding to the highest priority
request that is asserted. If a grant for a particular request is asserted, and a higher priority
request subsequently asserts, the arbiter de-asserts the asserted grant signal and asserts the
grant corresponding to the new higher priority request on the next PCI clock cycle. When
priorities are re-evaluated, the highest priority is assigned to the next highest priority
master relative to the master that initiated the previous transaction. The master that initiated
the last transaction now has the lowest priority in its group.
If PI7C8152x detects that an initiator has failed to assert S_FRAME_L after 16 cycles of
both grant assertion and a secondary idle bus condition, the arbiter de-asserts the grant.
Page 61 of 90
October 16, 2003 – Revision 1.11