LPC47M112_07 SMSC [SMSC Corporation], LPC47M112_07 Datasheet - Page 148

• Manufacturer Part Number: LPC47M112_07
• Description: Enhanced Super I/O Controller with LPC Interface
• Manufacturer: SMSC [SMSC Corporation]

Enhanced Super I/O Controller with LPC Interface
Datasheet
SMSC DS – LPC47M112
GP43
Default = 0x01
on VTR POR
Bits[3:2] are reset
(cleared) on VCC
POR, VTR POR and
Hard Reset
GP50
Default = 0x01
on VTR POR
GP51
Default = 0x01
on VTR POR
GP52
Default = 0x01
on VTR POR
NAME
REG OFFSET
(R/W)
(R/W)
(R/W)
(R/W)
(hex)
3E
3F
40
41
DATASHEET
General Purpose I/0 bit 4.3
Bit[0] In/Out : =1 Input, =0 Output
Bit[1] Polarity : =1 Invert, =0 No Invert
Bit[3:2] Alternate Function Select
11=Either Edge Triggered Interrupt Input 3 (Note 1), 10=
Reserved
01=Device Disable Register Control. The GP43 pin is an
input, with non-inverted polarity. When bits[3:2]=01, they
cannot be changed by writing to these bits; they are cleared
by VCC POR, Hard Reset and VTR POR. That is, when the
DDRC function is selected for this pin, it cannot be changed,
except by a VCC POR, Hard Reset or VTR POR.
The Device Disable register is controlled by the value of the
GP43 pin as follows:
If the GP43 pin is high, the Device Disable Register is
Read-Only.
If the GP43 pin is low, the Device Disable Register is
Read/Write.
00=Basic GPIO function
Bits[6:4] Reserved
Bit[7] Output Type Select
1=Open Drain
0=Push Pull
General Purpose I/0 bit 5.0
Bit[0] In/Out : =1 Input, =0 Output
Bit[1] Polarity : =1 Invert, =0 No Invert
Bit[3:2] Alternate Function Select
11=Reserved
10=Reserved
01=nRI2 (User Note 1)
00=GPIO
Bits[6:4] Reserved
Bit[7] Output Type Select
1=Open Drain
0=Push Pull
General Purpose I/0 bit 5.1
Bit[0] In/Out : =1 Input, =0 Output
Bit[1] Polarity : =1 Invert, =0 No Invert
Bit[3:2] Alternate Function Select
11=Reserved
10=Reserved
01=nDCD2
00=GPIO
Bits[6:4] Reserved
Bit[7] Output Type Select
1=Open Drain
0=Push Pull
General Purpose I/0 bit 5.2
Bit[0] In/Out : =1 Input, =0 Output
Bit[1] Polarity : =1 Invert, =0 No Invert
Bit[3:2] Alternate Function Select
11=Reserved
10=Reserved
01=RXD2
00=GPIO
Bits[6:4] Reserved
Bit[7] Output Type Select
1=Open Drain
0=Push Pull
Page 148
DESCRIPTION
Rev. 02-16-07