LPC47M112_07 SMSC [SMSC Corporation], LPC47M112_07 Datasheet - Page 42

• Manufacturer Part Number: LPC47M112_07
• Description: Enhanced Super I/O Controller with LPC Interface
• Manufacturer: SMSC [SMSC Corporation]

Enhanced Super I/O Controller with LPC Interface
Datasheet
SMSC DS – LPC47M112
MT
N
NCN
ND
OW
PCN
POLL
PRETRK
R
RCN
SC
SK
SRT
SYMBOL
Multi-Track
Selector
Sector Size Code
New Cylinder
Number
Non-DMA
Flag
Overwrite
Present Cylinder
Number
Polling Disable
Precompensation
Start Track
Number
Sector Address
Relative Cylinder
Number
Number of
Sectors Per Track
Skip Flag
Step Rate Interval
NAME
Mode
When set, this flag selects the multi-track operating mode. In this
mode, the FDC treats a complete cylinder under head 0 and 1 as a
single track. The FDC operates as this expanded track started at the
first sector under head 0 and ended at the last sector under head 1.
With this flag set, a multitrack read or write operation will
automatically continue to the first sector under head 1 when the FDC
finishes operating on the last sector under head 0.
This specifies the number of bytes in a sector. If this parameter is
"00", then the sector size is 128 bytes.
transferred is determined by the DTL parameter. Otherwise the
sector size is (2 raised to the "N'th" power) times 128. All values up
to "07" hex are allowable. "07"h would equal a sector size of 16k. It
is the user's responsibility to not select combinations that are not
possible with the drive.
N SECTOR SIZE
1024 Bytes
…
07 16K Bytes
The desired cylinder number.
When set to 1, indicates that the FDC is to operate in the non-DMA
mode. In this mode, the host is interrupted for each data transfer.
When set to 0, the FDC operates in DMA mode.
The bits D0-D3 of the Perpendicular Mode Command can only be
modified if OW is set to 1. OW id defined in the Lock command.
The current position of the head at the completion of Sense Interrupt
Status command.
When set, the internal polling routine is disabled. When clear, polling
is enabled.
Programmable from track 00 to FFH.
The sector number to be read or written. In multi-sector transfers,
this parameter specifies the sector number of the first sector to be
read or written.
Relative cylinder offset from present cylinder as used by the Relative
Seek command.
The number of sectors per track to be initialized by the Format
command. The number of sectors per track to be verified during a
Verify command when EC is set.
When set to 1, sectors containing a deleted data address mark will
automatically be skipped during the execution of Read Data. If Read
Deleted is executed, only sectors with a deleted address mark will be
accessed. When set to "0", the sector is read or written the same as
the read and write commands.
The time interval between step pulses issued by the FDC.
Programmable from 0.5 to 8 milliseconds in increments of 0.5 ms at
the 1 Mbit data rate. Refer to the SPECIFY command for actual
delays.
128 Bytes
256 Bytes
512 Bytes
DATASHEET
…
Page 42
DESCRIPTION
The number of bytes
Rev. 02-16-07