mcf5307cft90b Freescale Semiconductor, Inc, mcf5307cft90b Datasheet - Page 336

• Manufacturer Part Number: mcf5307cft90b
• Description: Mcf5307 Coldfire Integrated Microprocessor User
• Manufacturer: Freescale Semiconductor, Inc

Operation
Features of this local loop-back mode are as follows:
14.5.3.3 Remote Loop-Back Mode
In remote loop-back mode, shown in Figure 14-25, the channel automatically transmits
received data bit by bit on the TxD output. The local CPU-to-transmitter link is disabled.
This mode is useful in testing receiver and transmitter operation of a remote channel. For
this mode, the transmitter uses the receiver clock.
Because the receiver is not active, received data cannot be read by the CPU and error status
conditions are inactive. Received parity is not checked and is not recalculated for
transmission. Stop bits are sent as they are received. A received break is echoed as received
until the next valid start bit is detected.
14.5.4 Multidrop Mode
Setting UMR1n[PM] programs the UART to operate in a wake-up mode for multidrop or
multiprocessor applications. In this mode, a master can transmit an address character
followed by a block of data characters targeted for one of up to 256 slave stations.
Although slave stations have their channel receivers disabled, they continuously monitor
the master’s data stream. When the master sends an address character, the slave receiver
channel notifies its respective CPU by setting USRn[RxRDY] and generating an interrupt
(if programmed to do so). Each slave station CPU then compares the received address to its
station address and enables its receiver if it wishes to receive the subsequent data characters
or block of data from the master station. Slave stations not addressed continue monitoring
the data stream. Data fields in the data stream are separated by an address character. After
14-26
• Transmitter and CPU-to-receiver communications continue normally in this mode.
• RxD input data is ignored
• TxD is held marking
• The receiver is clocked by the transmitter clock. The transmitter must be enabled,
but the receiver need not be.
CPU
CPU
Freescale Semiconductor, Inc.
For More Information On This Product,
Figure 14-25. Remote Loop-Back
Disabled
Disabled
Figure 14-24. Local Loop-Back
Go to: www.freescale.com
MCF5307 User’s Manual
Rx
Tx
Rx
Tx
Disabled
Disabled
Disabled
Disabled
RxD Input
TxD Input
RxD Input
TxD Input