mcf5307cft90b Freescale Semiconductor, Inc, mcf5307cft90b Datasheet - Page 346

• Manufacturer Part Number: mcf5307cft90b
• Description: Mcf5307 Coldfire Integrated Microprocessor User
• Manufacturer: Freescale Semiconductor, Inc

Parallel Port Operation
15.1.2 Port A Data Direction Register (PADDR)
The PADDR determines the signal direction of each parallel port pin programmed as a
general-purpose I/O port in the PAR.
Table 15-2 describes PADDR fields.
15.1.3 Port A Data Register (PADAT)
The PADAT value for inputs corresponds to the logic level at the pin; for outputs, the value
corresponds to the logic level driven onto the pin. Note the following:
PP[15:8]/
A[31:24]
TIP/PP7
DREQ[1:0]/
PP[6:5]
TM[2:0]/
PP[4:2]]
TT[1:0]/
PP[1:0]
15-2
15–0
Bits
• PADAT has no effect on pins not configured for general-purpose I/O.
• PADAT settings do not affect inputs. PADAT bit values determine the corresponding
Pin
logic levels of pins configured as outputs.
Address
PADDR
Name
Reset
Field
R/W
MSB of the address bus/parallel port. Programmed through PAR[15–8]. If a PAR bit is 0, the associated
pin functions as a parallel port signal. If a bit is 1, the pin functions as an address bus signal. If all pins
are address signals, as much as 4 Gbytes of memory space are available.
Transfer-in-progress output/parallel port bit 7. Programmed through PAR[7]. Assertion indicates a bus
transfer is in progress; negation indicates an idle bus cycle if the bus is still granted to the processor.
Note that TIP is held asserted on back-to-back bus cycles.
DMA request inputs/two bits of the parallel port. Programmed through PAR[6–5]. These inputs are
asserted by a peripheral device to request a DMA transfer.
Transfer type outputs/parallel port bits 4–2. Programmed through PAR[4–2]. For DMA transfers, these
signals provide acknowledge information. For emulation transfers, TM[2:0] indicate user or data transfer
types. For CPU space transfers, TM[2:0] are low. For interrupt acknowledge transfers, TM[2:0] carry the
interrupt level being acknowledged.
Transfer type outputs/parallel port bits 1–0. Programmed through PAR[1–0].
When the MCF5307 is bus master, it outputs these signals. They indicate the current bus access type.
15
Data direction bits. Each data direction bit selects the direction of the signal as follows:
0 Signal is defined as an input.
1 Signal is defined as an output.
Figure 15-2. Port A Data Direction Register (PADDR)
Table 15-1. Parallel Port Pin Descriptions
Freescale Semiconductor, Inc.
Table 15-2. PADDR Field Description
For More Information On This Product,
Go to: www.freescale.com
MCF5307 User’s Manual
Address MBAR + 0x244
0000_0000_0000_0000
Description
PADDR
Description
R/W
0