s3c2410a Samsung Semiconductor, Inc., s3c2410a Datasheet - Page 76

• Manufacturer Part Number: s3c2410a
• Description: 16/32-bit Risc Arm Microprocessor
• Manufacturer: Samsung Semiconductor, Inc.

PROGRAMMER'S MODEL
EXCEPTIONS
Exceptions arise whenever the normal flow of a program has to be halted temporarily, for example to service an
interrupt from a peripheral. Before an exception can be handled, the current processor state must be preserved so
that the original program can resume when the handler routine has finished.
It is possible for several exceptions to arise at the same time. If this happens, they are dealt with in a fixed order.
See Exception Priorities on page 2-14.
Action on Entering an Exception
When handling an exception, the ARM920T:
1. Preserves the address of the next instruction in the appropriate Link Register. If the exception has been entered
2. Copies the CPSR into the appropriate SPSR
3. Forces the CPSR mode bits to a value which depends on the exception
4. Forces the PC to fetch the next instruction from the relevant exception vector
It may also set the interrupt disable flags to prevent otherwise unmanageable nestings of exceptions.
If the processor is in THUMB state when an exception occurs, it will automatically switch into ARM state when the
PC is loaded with the exception vector address.
Action on Leaving an Exception
On completion, the exception handler:
1. Moves the Link Register, minus an offset where appropriate, to the PC. (The offset will vary depending on the
2. Copies the SPSR back to the CPSR
3. Clears the interrupt disable flags, if they were set on entry
2-10
from ARM state, then the address of the next instruction is copied into the Link Register (that is, current PC + 4
or PC + 8 depending on the exception. See Table 2-2 on for details). If the exception has been entered from
THUMB state, then the value written into the Link Register is the current PC offset by a value such that the
program resumes from the correct place on return from the exception. This means that the exception handler
need not determine which state the exception was entered from. For example, in the case of SWI, MOVS PC,
R14_svc will always return to the next instruction regardless of whether the SWI was executed in ARM or
THUMB state.
type of exception.)
An explicit switch back to THUMB state is never needed, since restoring the CPSR from the SPSR
automatically sets the T bit to the value it held immediately prior to the exception.
NOTE
S3C2410A