CJ1W-NC234 Omron, CJ1W-NC234 Datasheet - Page 575

• Manufacturer Part Number: CJ1W-NC234
• Description: High Speed Pulse Train 2 Axes
• Manufacturer: Omron

Specifications of CJ1W-NC234

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

CJ Position Control Units OPERATION MANUAL (CJ1W-NC214/234/414/434)
*1.The PLC cycle time varies depending on a combined CPU and functions to be used. Refer to "Effect
Command
for
operation
External I/O connector
Software on the computer
side
on the Programmable Controller Cycle Time" on page Appendix-7.
Functions and
performances
Operating
area
Setting area Area common to all units: Special I/O
Use each of the areas below for the
functions and the number of axes to be
used.
Unit Memory area
Manual Operation Command Memory
area, Direct Operation Command
Memory area, Axis Status Memory area,
Memory Operation Command Memory
area and Memory Operation Status
Memory area: You can set each of these
in a desired area of CIO, WR, DM and
EM.
50 pins/2 axes (Servo Drive I/O)
20 pins/2 axes (external control I/O)
* Install 2 sets of each of the above for 4-
axis PCU.
CX-Programmer
area
area
area
area
Manual Operation Command Memory
Memory Operation Command Memory
Unit Common Memory area
Direct Operation Command Memory
Axis Status Memory area
Memory Operation Status Memory
CJ1W-NC2x4/4x4
Appendix-2 Changes from the Existing PCU
Use these 2 areas. (Fixed size)
Operating area: Special I/O Unit
Memory area in CIO area
Operation data: You can set this
up in the special I/O unit area in
DM area, a desired DM area and
a desired EM area.
40 pins/2 axes (Servo Drive I/O
and external control I/O)
* Install 2 sets of the above for 4-
axis PCU.
CX-Position
Operation Memory area
Operation data
CJ1W-NC1x3/2x3/4x3
Appendix-10
A