CJ1W-NC434 Omron, CJ1W-NC434 Datasheet - Page 318

• Manufacturer Part Number: CJ1W-NC434
• Description: High Speed Pulse Train 4 Axes
• Manufacturer: Omron

Specifications of CJ1W-NC434

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

7
7-3 Memory Operation
7-17
PSET
*1.Selection is possible only when you use this signal as a general-purpose output.
Sequence data that forcibly turns ON the PCU outputs.
If you set a PSET instruction under [Command], you can set the 3 types of sequence data
below.
You can forcibly output only the signals for the configuration axis of the applicable task.
Outputs are retained during memory operation, and the PSET instruction is canceled when
memory operation stops.
This instruction operates based on the OR with any output instruction from the PLC.
You can select the RUN output and error counter output only when you use them as general-
purpose outputs. If you select the RUN output and error counter output for PSET when they
have already been selected as the RUN output and error counter output functions, an error
occurs. For the settings of the RUN output and error counter reset, refer to "I/O Function
Selection" on page 5-19.
Command
Sequence start
condition
Output signal
Data name
Select [PSET].
Use a memory operation condition data number to set the starting condition.
You can also set this item to no condition.
Specify the destination of forced output.
0000 hex: No output
##00 hex: RUN Output
##01 hex: Drive alarm reset output
##02 hex: Error counter reset output
##03 hex: General-purpose output
##04 hex: Torque limit output
##: 01 to 04
8000 to 800F hex: Memory Operation Auxiliary Memory area
(Physical Axis 01: Axis 1, 02: Axis 2, 03: Axis 3, 04: Axis 4)
(8,000 to 800F hex correspond to bits 0 to 15, respectively.)
CJ Position Control Units OPERATION MANUAL (CJ1W-NC214/234/414/434)
*1
Function
*1