C8051F34A-GMR Silicon Labs, C8051F34A-GMR Datasheet - Page 118

• Manufacturer Part Number: C8051F34A-GMR
• Description: 8-bit Microcontrollers - MCU 48 MIPS 64KB 10ADC
• Manufacturer: Silicon Labs

Specifications of C8051F34A-GMR

• Rohs: yes
• Core: 8051
• Processor Series: C8051
• Data Bus Width: 8 bit

C8051F340/1/2/3/4/5/6/7/8/9/A/B/C/D
118
Bit7:
Bit6:
Bit5:
Bit4:
Bits3–2: EMD1–0: EMIF Operating Mode Select.
Bits1–0: EALE1–0: ALE Pulse-Width Select Bits (only has effect when EMD2 = 0).
R/W
Bit7
-
Unused. Read = 0b. Write = don’t care.
USBFAE: USB FIFO Access Enable.
0: USB FIFO RAM not available through MOVX instructions.
1: USB FIFO RAM available using MOVX instructions. The 1k of USB RAM will be mapped
in XRAM space at addresses 0x0400 to 0x07FF. The USB clock must be active and
greater than or equal to twice the SYSCLK (USBCLK > 2 x SYSCLK) to access this
area with MOVX instructions.
Unused. Read = 0b. Write = don’t care.
EMD2: EMIF Multiplex Mode Select.
0: EMIF operates in multiplexed address/data mode.
1: EMIF operates in non-multiplexed mode (separate address and data pins).
These bits control the operating mode of the External Memory Interface.
00: Internal Only: MOVX accesses on-chip XRAM only. All effective addresses alias to
on-chip memory space.
01: Split Mode without Bank Select: Accesses below the on-chip XRAM boundary are
directed on-chip. Accesses above the on-chip XRAM boundary are directed off-chip. 8-bit
off-chip MOVX operations use the current contents of the Address High port latches to
resolve upper address byte. Note that in order to access off-chip space, EMI0CN must be
set to a page that is not contained in the on-chip address space.
10: Split Mode with Bank Select: Accesses below the on-chip XRAM boundary are directed
on-chip. Accesses above the on-chip XRAM boundary are directed off-chip. 8-bit off-chip
MOVX operations use the contents of EMI0CN to determine the high-byte of the address.
11: External Only: MOVX accesses off-chip XRAM only. On-chip XRAM is not visible to the
CPU.
00: ALE high and ALE low pulse width = 1 SYSCLK cycle.
01: ALE high and ALE low pulse width = 2 SYSCLK cycles.
10: ALE high and ALE low pulse width = 3 SYSCLK cycles.
11: ALE high and ALE low pulse width = 4 SYSCLK cycles.
SFR Definition 13.2. EMI0CF: External Memory Configuration
USBFAE
R/W
Bit6
R/W
Bit5
-
EMD2
R/W
Bit4
Rev. 1.3
EMD1
R/W
Bit3
EMD0
R/W
Bit2
EALE1
R/W
Bit1
SFR Address: 0x85
EALE0
R/W
Bit0
00000011
Reset Value