R8A77850ANBGV Renesas Electronics America, R8A77850ANBGV Datasheet - Page 1050

• Manufacturer Part Number: R8A77850ANBGV
• Description: IC SUPERH MPU ROMLESS 436-BGA
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7780r

Specifications of R8A77850ANBGV

• Core Processor: SH-4A
• Core Size: 32-Bit
• Speed: 600MHz
• Connectivity: Audio Codec, MMC, Serial Sound, SCI, SIO, SPI, SSI
• Peripherals: DMA, POR, WDT
• Number Of I /o: 108
• Program Memory Type: ROMless
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 1 V ~ 1.2 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 436-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

20. Graphics Data Translation Accelerator (GDTA)
Rev.1.00 Jan. 10, 2008 Page 1018 of 1658
REJ09B0261-0100
Yes
[Step (1) Clear the CL access mask]
After the CPU sets the key code in GACMR within the bus interface, set GACER to enable access to the CL function block.
[Step (2) Initialize the CL function block]
The CPU sets the frame width/height, input Y/UV padding size, output padding size, and output data/address mode.
In ARGB conversion mode, CLPLPR should also be set.
[Step (3) Write the color conversion table to RAM 0]
The CPU writes the color conversion table to RAM 0.
* Step (3) is not necessary in YUYV conversion mode; it is only required in ARGB conversion mode.
[Step (4) Write to the command FIFO]
The CPU writes commands to CLCF. Four command parameters are required
and should be written in succession in the following order:
(1) Data for writing: Input Y pointer
(2) Data for writing: Input U pointer
(3) Data for writing: Input V pointer
(4) Data for writing: Output pointer
[Step (5) Wait for processing completion]
Processing completion is judged using an interrupt from the CPU or the CL_END bit in GACISR.
(Check the CK_CFF bit in CLSR.)
Is the CL command FIFO full?
Figure 20.5 CL Processing Procedure
No
No
timed by interrupt or setting of the
Is continuous processing
Continuous processing?
CL_END bit in GACISR?
Next processing?
Start
End
Yes
Yes
No
Yes
No
for CL processing?
Change settings
Yes
No