IP-POSPHY4 Altera, IP-POSPHY4 Datasheet - Page 95

• Manufacturer Part Number: IP-POSPHY4
• Description: IP CORE - POS-PHY Level 4 SPI 4.2 Interface
• Manufacturer: Altera
• Type: MegaCorer

Specifications of IP-POSPHY4

• Software Application: IP CORE, Interface And Protocols, COMMUNICATION
• Supported Families: Arria GX, Cyclone, HardCopy, Stratix
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Rohs Compliant: NA
• Function: POS-PHY Level 4 Interface, Link-Layer/PHY Layer
• License: Initial License
• Lead Free Status / RoHS Status: na
• Lead Free Status / RoHS Status: na

Chapter 5: Functional Description—Transmitter
Signals
Table 5–8. Data Path and Control Status (Part 2 of 2)
December 2010 Altera Corporation
ctl_td_alpha[7:0]
ctl_td_burstlen[9:0]
ctl_td_burstlimit[10:0]
Signal
Input
Input
Input
Direction
tdint_clk
Clock Domain
Number of training pattern sequence repetitions. This
value only applies to interval training patterns. If a
training pattern is inserted due to stat_ts_sync
deasserted, the training pattern lasts until
stat_ts_sync is asserted, and the current 20-cycle
training pattern completes. Setting to zero results in
an ALPHA of 256. Only change at reset.
■
■
■
■
Sets the maximum burst size to be sent by the
transmitter. A control word is inserted at the end of
the burst limit. Burst limit values are restricted to
multiples of burst unit size (set via
ctl_td_burstlen[9:0]), and depending on other
transmitter parameters, the values may be limited to
a minimum value. You can use IP Toolbench to
determine the valid values (set Parameter Type to
Fixed Value to determine the valid values, and then
set back to Real Time Programmable). The units are
in bytes.
For the individual buffers mode, this input sets the
legal burst unit size, formerly known as burst
length. A burst must end on either a non-zero
multiple of ctl_td_burstlen, or on an EOP.
For the shared buffer with embedded addressing
mode, this input only limits when the MegaCore
function may read data from the buffer. This input
enables delineating bursts, as in the individual
buffers case, only if the user logic pushes bursts
into the buffer with the desired delineation.
In either mode, this input also delays insertion of
training patterns after MaxT so that bursts are not
interrupted.
Units are in bytes. Supports M to 1,024 bytes in
increments of M, where M equals 16 or 32 bytes
depending on the Atlantic buffer width.
POS-PHY Level 4 MegaCore Function User Guide
Description
5–23