EP2SGX90EF1152C4N Altera, EP2SGX90EF1152C4N Datasheet - Page 288

• Manufacturer Part Number: EP2SGX90EF1152C4N
• Description: IC STRATIX II GX 90K 1152-FBGA
• Manufacturer: Altera
• Series: Stratix® II GXr

Specifications of EP2SGX90EF1152C4N

• Number Of Logic Elements/cells: 90960
• Number Of Labs/clbs: 4548
• Total Ram Bits: 4520448
• Number Of I /o: 558
• Voltage - Supply: 1.15 V ~ 1.25 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 1152-FBGA
• Family Name: Stratix II GX
• Number Of Logic Blocks/elements: 90960
• # I/os (max): 558
• Frequency (max): 732.1MHz
• Process Technology: SRAM
• Operating Supply Voltage (typ): 1.2V
• Logic Cells: 90960
• Ram Bits: 4520448
• Operating Supply Voltage (min): 1.15V
• Operating Supply Voltage (max): 1.25V
• Operating Temp Range: 0C to 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 1152
• Package Type: FC-FBGA
• For Use With: 544-1725 - PCIE KIT W/S II GX EP2SGX90N544-1724 - SI KIT W/SII GX EP2SGX90N544-1702 - VIDEO KIT W/SII GX EP2SGX90N
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Compliant
• Other names: 544-1767; EP2SGX90EF35C4NES

Duty Cycle
Distortion
Duty cycle distortion (DCD) describes how much the falling edge of a
clock is off from its ideal position. The ideal position is when both the
clock high time (CLKH) and the clock low time (CLKL) equal half of the
clock period (T), as shown in
non-ideal falling edge from the ideal falling edge, such as D1 for the
falling edge A and D2 for the falling edge B (see
maximum DCD for a clock is the larger value of D1 and D2.
Figure 4–11. Duty Cycle Distortion
DCD expressed in absolution derivation, for example, D1 or D2 in
Figure
percentage, and the percentage number is clock-period dependent. DCD
as a percentage is defined as:
DCD Measurement Techniques
DCD is measured at an FPGA output pin driven by registers inside the
corresponding I/O element (IOE) block. When the output is a single data
rate signal (non-DDIO), only one edge of the register input clock (positive
or negative) triggers output transitions
DCD present on the input clock signal or caused by the clock input buffer
or different input I/O standard does not transfer to the output signal.
(T/2 – D1) / T (the low percentage boundary)
(T/2 + D2) / T (the high percentage boundary)
4–11, is clock-period independent. DCD can also be expressed as a
CLKH = T/2
Falling Edge A
Figure
Ideal Falling Edge
Clock Period (T)
D1
4–11. DCD is the deviation of the
D2
Falling Edge B
(Figure
CLKL = T/2
4–12). Therefore, any
Figure
4–11). The