HD64F2239TF20I Renesas Electronics America, HD64F2239TF20I Datasheet - Page 858

• Manufacturer Part Number: HD64F2239TF20I
• Description: MCU 3V 384K I-TEMP 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of HD64F2239TF20I

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 24 Power-Down Modes
24.6
Module stop mode can be set for individual on-chip peripheral modules.
When the corresponding MSTP bit in MSTPCR is set to 1, module operation stops at the end of
the bus cycle and a transition is made to module stop mode. The CPU continues operating
independently.
When the corresponding MSTP bit is cleared to 0, module stop mode is cleared and the module
starts operating at the end of the bus cycle. In module stop mode, the internal states of modules
other than SCI and the A/D converter are retained.
After reset clearance, all modules other than DMAC* and DTC are in module stop mode.
When an on-chip peripheral module is in module stop mode, read/write access to its registers is
disabled.
Since the operations of the bus controller and I/O port are stopped when sleep mode is entered at
the all-module stop state (MSTPCR = H'FFFFFFFF), power consumption can further be reduced.
Note: * Supported only by the H8S/2239 Group.
Rev. 6.00 Mar. 18, 2010 Page 796 of 982
REJ09B0054-0600
Oscillator
RES
STBY
Module Stop Mode
Figure 24.4 Hardware Standby Mode Timing
Oscillation
settling
time t
osc1
exception
handling
Reset