AT91SAM7S256D-AU Atmel, AT91SAM7S256D-AU Datasheet - Page 415

• Manufacturer Part Number: AT91SAM7S256D-AU
• Description: ARM Microcontrollers - MCU 256K Flash SRAM 64K ARM based MCU
• Manufacturer: Atmel
• Series: SAM7S256r

Specifications of AT91SAM7S256D-AU

• Rohs: yes
• Core: ARM
• Processor Series: AT91SAM
• Data Bus Width: 16 bit/32 bit
• Maximum Clock Frequency: 55 MHz
• Program Memory Size: 256 KB
• Data Ram Size: 64 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3 V to 3.6 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: LQFP-64
• Mounting Style: SMD/SMT
• Interface Type: 2-Wire, I2S, SPI, USART
• Length: 7 mm

Figure 32-9. Receiver Block Diagram
32.6.4
SSC_RCMR.STTDLY
Receiver Clock
The frame synchronization is configured setting the Receive Frame Mode Register (SSC_RFMR).
Sync” on page 417.
The receiver uses a shift register clocked by the receiver clock signal and the start mode selected in the
SSC_RCMR. The data is transferred from the shift register depending on the data format selected.
When the receiver shift register is full, the SSC transfers this data in the holding register, the status flag RXRDY is
set in SSC_SR and the data can be read in the receiver holding register. If another transfer occurs before read of
the RHR register, the status flag OVERUN is set in SSC_SR and the receiver shift register is transferred in the
RHR register.
The transmitter and receiver can both be programmed to start their operations when an event occurs, respectively
in the Transmit Start Selection (START) field of SSC_TCMR and in the Receive Start Selection (START) field of
SSC_RCMR.
Under the following conditions the start event is independently programmable:
A start can be programmed in the same manner on either side of the Transmit/Receive Clock Register
(RCMR/TCMR). Thus, the start could be on TF (Transmit) or RF (Receive).
Moreover, the Receiver can start when data is detected in the bit stream with the Compare Functions.
Detection on TF/RF input/output is done by the field FSOS of the Transmit/Receive Frame Mode Register
(TFMR/RFMR).
• Continuous. In this case, the transmission starts as soon as a word is written in SSC_THR and the reception
• Synchronously with the transmitter/receiver
• On detection of a falling/rising edge on TF/RF
• On detection of a low level/high level on TF/RF
• On detection of a level change or an edge on TF/RF
Start
starts as soon as the Receiver is enabled.
RF
Selector
Start
TF
SSC_RFMR.MSBF
SSC_RFMR.FSLEN
SSC_RSHR
Receive Shift Register
SSC_RFMR.DATNB
SSC_RFMR.DATLEN
SSC_RHR
SSC_CR.RXEN
SSC_CR.RXDIS
SSC_SR.RXEN
SAM7S Series [DATASHEET]
6175M–ATARM–26-Oct-12
See “Frame
RD
415