AT91SAM7S256D-AU Atmel, AT91SAM7S256D-AU Datasheet - Page 526

• Manufacturer Part Number: AT91SAM7S256D-AU
• Description: ARM Microcontrollers - MCU 256K Flash SRAM 64K ARM based MCU
• Manufacturer: Atmel
• Series: SAM7S256r

Specifications of AT91SAM7S256D-AU

• Rohs: yes
• Core: ARM
• Processor Series: AT91SAM
• Data Bus Width: 16 bit/32 bit
• Maximum Clock Frequency: 55 MHz
• Program Memory Size: 256 KB
• Data Ram Size: 64 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3 V to 3.6 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: LQFP-64
• Mounting Style: SMD/SMT
• Interface Type: 2-Wire, I2S, SPI, USART
• Length: 7 mm

• SOFINT: Start of Frame Interrupt Status
0 = No Start of Frame Interrupt pending.
1 = Start of Frame Interrupt has been raised.
This interrupt is raised each time a SOF token has been detected. It can be used as a synchronization signal by using
isochronous endpoints.
• ENDBUSRES: End of BUS Reset Interrupt Status
0 = No End of Bus Reset Interrupt pending.
1 = End of Bus Reset Interrupt has been raised.
This interrupt is raised at the end of a UDP reset sequence. The USB device must prepare to receive requests on the end-
point 0. The host starts the enumeration, then performs the configuration.
• WAKEUP: UDP Resume Interrupt Status
0 = No Wakeup Interrupt pending.
1 = A Wakeup Interrupt (USB Host Sent a RESUME or RESET) occurred since the last clear.
After reset the state of this bit is undefined, the application must clear this bit by setting the WAKEUP flag in the UDP_ ICR
register.
SAM7S Series [DATASHEET]
526
6175M–ATARM–26-Oct-12