IPR-HPMCII Altera, IPR-HPMCII Datasheet - Page 171

• Manufacturer Part Number: IPR-HPMCII
• Description: IP CORE Renewal Of IP-HPMCII
• Manufacturer: Altera

Specifications of IPR-HPMCII

• Software Application: IP CORE, Memory Controllers, SDRAM
• Supported Families: Arria II GX, HardCopy III, Stratix III, Stratix IV
• Core Architecture: FPGA
• Core Sub-architecture: Arria, HardCopy, Stratix
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: na

Chapter 9: Timing Diagrams
DDR3 High-Performance Controllers II
December 2010 Altera Corporation
The following sequence corresponds with the numbered items in
1. The user logic asserts the first local_write_req signal with a size of 1 and an
2. The user logic asserts a second local_write_req signal with a size of 1 and
3. The controller issues the necessary memory command and address signals to the
4. The controller asserts the afi_wdata_valid signal to indicate to the ALTMEMPHY
5. The controller asserts the afi_dqs_burst signals to control the timing of the DQS
6. The ALTMEMPHY megafunction issues the write command, and sends the write
address of 0×000000. The local_ready signal is asserted along with the
local_write_req signal, which indicates that the controller has accepted this
request, and the user logic can request another read or write in the following clock
cycle. If the local_ready signal was not asserted, the user logic must keep the
write request, size, and address signals asserted until the local_ready signal is
registered high. The local address 0x000000 is mapped to the following memory
address in half-rate mode:
mem_row_address = 0×0000
mem_col_address = 0×0000<<2 = 0×0000
mem_bank_address = 0×00
address of 1. The local_ready signal is asserted along with the local_write_req
signal, which indicates that the controller has accepted this request. Since the
second write request is to a sequential address (same row, same bank, and column
increment by 1), this write and the first write can be merged at the memory
transaction.
ALTMEMPHY megafunction for it to send to the memory device.
megafunction that valid write data and write data masks are present on the inputs
to the ALTMEMPHY megafunction.
signal that the ALTMEMPHY megafunction issues to the memory.
data and write DQS to the memory.
Section II. DDR3 SDRAM Controller with ALTMEMPHY IP User Guide
External Memory Interface Handbook Volume 3
Figure
9–14:
9–25