SAM3S1A Atmel Corporation, SAM3S1A Datasheet - Page 421

• Manufacturer Part Number: SAM3S1A
• Manufacturer: Atmel Corporation

Specifications of SAM3S1A

• Flash (kbytes): 64 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 64 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 2
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 1000
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

25. Clock Generator
25.1
25.2
6500C–ATARM–8-Feb-11
Description
Embedded Characteristics
The Clock Generator User Interface is embedded within the Power Management Controller and
is described in
the Clock Generator registers are named CKGR_.
The Clock Generator is made up of:
It provides the following clocks:
PLLBCK is the output of the Divider and 60 to 130 MHz programmable PLL (PLLB)
• A Low Power 32,768 Hz Slow Clock Oscillator with bypass mode
• A Low Power RC Oscillator
• A 3 to 20 MHz Crystal or Ceramic Resonator-based Oscillator which can be bypassed
• A factory programmed Fast RC Oscillator, 3 output frequencies can be selected: 4, 8 or
• Two 60 to 130 MHz programmable PLL (input from 3.5 to 20 MHz), capable of providing the
• SLCK, the Slow Clock, which is the only permanent clock within the system
• MAINCK is the output of the Main Clock Oscillator selection: either the Crystal or Ceramic
• PLLACK is the output of the Divider and 60 to 130 MHz programmable PLL (PLLA)
12 MHz. By default 4 MHz is selected.
clock MCK to the processor and to the peripherals.
Resonator-based Oscillator or 4/8/12 MHz Fast RC Oscillator
Section 26.16 ”Power Management Controller (PMC) User
Interface”. However,
SAM3S
421