LPC47M182 SMSC Corporation, LPC47M182 Datasheet - Page 108

• Manufacturer Part Number: LPC47M182
• Description: ADVANCED I/O CONTROLLER WITH MOTHERBOARD GLUE LOGIC
• Manufacturer: SMSC Corporation

7.12.7 cnfgA (Configuration Register A)
7.12.8 cnfgB (Configuration Register B)
7.12.9 ecr (Extended Control Register)
Revision 1.8 SMSC/Non-SMSC Register Sets (02-24-05)
ADDRESS OFFSET = 400H
Mode = 111
This register is a read only register. When read, 10H is returned. This indicates to the system that this is an
8-bit implementation. (PWord = 1 byte)
ADDRESS OFFSET = 401H
Mode = 111
BIT 7 compress
This bit is read only. During a read it is a low level. This means that this chip does not support hardware
RLE compression. It does support hardware de-compression.
BIT 6 intrValue
Returns the value of the interrupt to determine possible conflicts.
BIT [5:3] Parallel Port IRQ (read-only)
to Table 7.7
BITS [2:0] Parallel Port DMA (read-only)
to Table 7.8
ADDRESS OFFSET = 402H
Mode = all
This register controls the extended ECP parallel port functions.
BITS 7,6,5
These bits are Read/Write and select the Mode.
BIT 4 nErrIntrEn
Read/Write (Valid only in ECP Mode)
1:
0:
generated if nFault is asserted (interrupting) and this bit is written from a 1 to a 0. This prevents interrupts
from being lost in the time between the read of the ecr and the write of the ecr.
BIT 3 dmaEn
Read/Write
1:
0:
BIT 2 serviceIntr
Read/Write
1:
0:
occurred serviceIntr bit shall be set to a 1 by hardware. It must be reset to 0 to re-enable the interrupts.
Writing this bit to a 1 will not cause an interrupt.
Disables the interrupt generated on the asserting edge of nFault.
Enables an interrupt pulse on the high to low edge of nFault. Note that an interrupt will be
Enables DMA (DMA starts when serviceIntr is 0).
Disables DMA unconditionally.
Disables DMA and all of the service interrupts.
Enables one of the following 3 cases of interrupts. Once one of the 3 service interrupts has
DATASHEET
108
Advanced I/O Controller with Motherboard GLUE Logic
SMSC LPC47M182
Datasheet