LPC47M182 SMSC Corporation, LPC47M182 Datasheet - Page 180

• Manufacturer Part Number: LPC47M182
• Description: ADVANCED I/O CONTROLLER WITH MOTHERBOARD GLUE LOGIC
• Manufacturer: SMSC Corporation

Note:
Note 1: The default value of the DMA Channel Select register for logical device 0 (FDD) is 0x02 and for
Note A. Logical Device IRQ and DMA Operation
1.
A. FDC: For the following cases, the IRQ and DMA channel used by the FDC are disabled.
Digital Output Register (Base+2) bit D3 (DMAEN) set to “0”.
The FDC is in power down (disabled).
B. Serial Port:
Modem Control Register (MCR) Bit D2 (OUT2) - When OUT2 is a logic “0”, the serial port interrupt is disabled.
C. Parallel Port:
I.
ii.
D. Keyboard Controller: Refer to the KBD section of this spec.
Revision 1.8 SMSC/Non-SMSC Register Sets (02-24-05)
IRQ and DMA Enable and Disable: Any time the IRQ or DMA channel for a logical block is disabled by a register bit
in that logical block, the IRQ and/or DMA channel must be disabled. This is in addition to the IRQ and DMA
channel disabled by the Configuration Registers (active bit or address not valid).
SPP and EPP modes: Control Port (Base+2) bit D4 (IRQE) set to “0”, IRQ is disabled.
ECP Mode:
(1) (DMA) dmaEn from ecr register. See table.
(2) IRQ - See table.
A DMA channel is activated by setting the DMA Channel Select register to [0x01-0x03] AND :
The DMA channel must be disabled if not used/selected by any Logical Device. Refer to Note A.
logical device 3 is 0x04.
For the FDC logical device by setting DMAEN, bit D3 of the Digital Output Register.
For the PP logical device in ECP mode by setting dmaEn, bit D3 of the ecr.
(FROM ECR REGISTER)
000
001
010
011
100
101
110
111
MODE
PRINTER
CONFIG
TEST
FIFO
SPP
ECP
EPP
RES
DATASHEET
180
CONTROLLED BY
IRQE
IRQE
IRQE
IRQE
IRQE
IRQ
(on)
(on)
(on)
Advanced I/O Controller with Motherboard GLUE Logic
CONTROLLED BY
dmaEn
dmaEn
dmaEn
dmaEn
dmaEn
dmaEn
dmaEn
dmaEn
DMA
SMSC LPC47M182
Datasheet