LPC47M182 SMSC Corporation, LPC47M182 Datasheet - Page 192

• Manufacturer Part Number: LPC47M182
• Description: ADVANCED I/O CONTROLLER WITH MOTHERBOARD GLUE LOGIC
• Manufacturer: SMSC Corporation

Chapter 12 Electrical Characteristics
12.1
Note:
12.2
(T
I Input Buffer
Low Input Level
High Input Level
IPU Input Buffer
Low Input Level
High Input Level
Pull-Up
IS Input Buffer
Low Input Level
High Input Level
Schmitt Trigger Hystersis
Revision 1.8 SMSC/Non-SMSC Register Sets (02-24-05)
A
= 0
o
C to 70
PARAMETER
Maximum Guaranteed Ratings
Maximum 3.3 Supply ............................................................................................................................ +4.1V
Maximum 5V Supply ............................................................................................................................. +6.0V
Voltage on any 3.3V pin, with respect to Ground ......................................................................... -0.5 to 5.5V
Voltage on any 5V pin, with respect to Ground ............................................................................ -0.5 to 5.5V
Operating Temperature Range .................................................................................................. 0
Storage Temperature Range .................................................................................................. -55
Lead Temperature Range (lead-free, P/N LPC47N182-NW) ..................Refer to JEDEC Spec. J-STD-020B
Lead Temperature Range (leaded, P/N LPC47N182-NR) ........................ Refer to JEDEC Spec. J-STD-020
Stresses above those listed above and below could cause permanent damage to the device. This is a
stress rating only and functional operation of the device at any other condition above those indicated in the
operation sections of this specification is not implied. When powering this device from laboratory or
system power supplies, it is important that the Absolute Maximum Ratings not be exceeded or device
failure can result. Some power supplies exhibit voltage spikes on their outputs when the AC power is
switched on or off. In addition, voltage transients on the AC power line may appear on the DC output. If
this possibility exists, it is suggested that a clamp circuit be used.
Operational DC Characteristics
o
C)
SYMBOL
Table 12.1 – Operational DC Characteristics
V
V
V
PU
V
V
V
V
HYS
IH
IH
IH
IL
IL
IL
DATASHEET
MIN
2.0
2.0
2.2
192
TYP
250
30
MAX
0.8
5.5
0.8
5.5
0.8
5.5
Advanced I/O Controller with Motherboard GLUE Logic
UNITS
mV
uA
V
V
V
V
V
V
TTL Levels
TTL Levels
TTL Levels
TTL Levels
Schmitt Trigger
Schmitt Trigger
COMMENTS
SMSC LPC47M182
o
o
C to +70
to +150
Datasheet
o
o
C
C