LPC47M192-NW Standard Microsystems (SMSC), LPC47M192-NW Datasheet - Page 46

• Manufacturer Part Number: LPC47M192-NW
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LPC47M192-NW

• Lead Free Status / RoHS Status: Compliant

SMSC DS – LPC47M192
N
SYMBOL
PRETRK
H/HDS
LOCK
POLL
MFM
GAP
HUT
NCN
PCN
GPL
HLT
OW
MT
ND
R
Sector Size Code
Precompensation
Head Load Time
Present Cylinder
Non-DMA Mode
MFM/FM Mode
Sector Address
Polling Disable
Head Address
Head Unload
New Cylinder
Gap Length
Multi-Track
Start Track
Overwrite
Selector
Selector
Number
Number
Number
NAME
Time
Flag
Table 16 – Description of Command Symbols
Alters Gap 2 length when using Perpendicular Mode.
The Gap 3 size. (Gap 3 is the space between sectors excluding the
VCO synchronization field).
Selected head: 0 or 1 (disk side 0 or 1) as encoded in the sector ID
field.
The time interval that FDC waits after loading the head and before
initializing a read or write operation. Refer to the Specify command
for actual delays.
The time interval from the end of the execution phase (of a read or
write command) until the head is unloaded. Refer to the Specify
command for actual delays.
Lock defines whether EFIFO, FIFOTHR, and PRETRK parameters of
the CONFIGURE COMMAND can be reset to their default values by
a “software Reset”. (A reset caused by writing to the appropriate bits
of either the DSR or DOR)
A one selects the double density (MFM) mode. A zero selects single
density (FM) mode.
When set, this flag selects the multi-track operating mode. In this
mode, the FDC treats a complete cylinder under head 0 and 1 as a
single track. The FDC operates as this expanded track started at the
first sector under head 0 and ended at the last sector under head 1.
With this flag set, a multitrack read or write operation will
automatically continue to the first sector under head 1 when the FDC
finishes operating on the last sector under head 0.
This specifies the number of bytes in a sector. If this parameter is
"00", then the sector size is 128 bytes.
transferred is determined by the DTL parameter. Otherwise the
sector size is (2 raised to the "N'th" power) times 128. All values up
to "07" hex are allowable. "07"h would equal a sector size of 16k. It
is the user's responsibility to not select combinations that are not
possible with the drive.
N
00
01
02
03
…
07
The desired cylinder number.
Write ‘0’. This part does not support non-DMA mode.
The bits D0-D3 of the Perpendicular Mode Command can only be
modified if OW is set to 1. OW id defined in the Lock command.
The current position of the head at the completion of Sense Interrupt
Status command.
When set, the internal polling routine is disabled. When clear, polling
is enabled.
Programmable from track 00 to FFH.
The sector number to be read or written. In multi-sector transfers,
this parameter specifies the sector number of the first sector to be
read or written.
DATASHEET
SECTOR SIZE
16K Bytes
128 Bytes
256 Bytes
512 Bytes
1024 Bytes
…
Page 46
DESCRIPTION
The number of bytes
Rev. 03/30/05