SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 235

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

ARM DDI 0029G
•
For input cells, the capture stage involves copying the value of the system input to the
core into the serial register. During shift, this value is output serially. The value applied
to the core from an input cell is either the system input or the contents of the serial
register and this is controlled by the multiplexor.
For output cells, capture involves placing the output value of a core into the serial
register. During shift, this value is serially output as before. The value applied to the
system from an output cell is either the core output, or the contents of the serial register.
All of the control signals for the scan cells are generated internally by the TAP
controller. The action of the TAP controller is determined by the current instruction and
the state of the TAP state machine.
There are three basic modes of operation of the scan chains, INTEST, EXTEST, and
SYSTEM that are selected by the various TAP controller instructions:
•
•
System data in
CAPTURE clock
SHIFT clock
SHIFT.
In INTEST mode, the core is internally tested. The data serially scanned in is
applied to the core and the resulting outputs are captured in the output cells and
scanned out.
In EXTEST mode, data is scanned onto the outputs of the core and applied to the
external system. System input data is captured in the input cells and then shifted
out.
Copyright © 1994-2001. All rights reserved.
Serial data out
Serial data in
register
latch
Shift
Figure B-4 Input scan cell
Data to core
Debug in Depth
B-17