SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 279

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Status registers
SP
SWI
TAP
Test Access Port
Thumb instruction
Thumb state
UND
Undefined
UNP
Unpredictable
Unpredictable fields
Watchpoint
ARM DDI 0029G
See Program Status Register.
See Stack pointer
See Software Interrupt Instruction.
See Test access port.
The collection of four mandatory and one optional terminals that form the input/output
and control interface to a JTAG boundary-scan architecture. The mandatory terminals
are TDI, TDO, TMS, and TCK. The optional terminal is nTRST.
A halfword which specifies an operation for an ARM processor in Thumb state to
perform. Thumb instructions must be halfword-aligned.
A processor that is executing Thumb (16-bit) instructions is operating in Thumb state.
See Undefined.
Indicates an instruction that generates an undefined instruction trap.
See Unpredictable
Means the result of an instruction cannot be relied upon. Unpredictable instructions
must not halt or hang the processor, or any parts of the system.
Do not contain valid data, and a value can vary from moment to moment, instruction to
instruction, and implementation to implementation.
A location in the image that is monitored. If the value stored there changes, the debugger
halts execution of the image.
See also Breakpoint.
Copyright © 1994-2001. All rights reserved.
Glossary-5
Glossary