Z16F2800100ZCOG Zilog, Z16F2800100ZCOG Datasheet - Page 194

• Manufacturer Part Number: Z16F2800100ZCOG
• Description: DEV KIT FOR Z16F ZNEO
• Manufacturer: Zilog
• Series: ZNEO™r
• Type: MCUr

Specifications of Z16F2800100ZCOG

• Contents: Evaluation Board, Software and Documentation
• For Use With/related Products: Z16F Series
• For Use With: 269-4661 - KIT ACC ETHERNET SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4537

ESPI Register Overview
PS022008-0810
Comparison with Basic SPI Block
controlled by the SSIO bit of the ESPI mode register. The SS signal is an input on slave
devices and is an output on the active master device. Slave devices ignore transactions on
the bus unless their slave select input is asserted. In SPI MASTER mode, additional GPIO
pins are required to provide Slave Selects if there is more than one slave device.
The ESPI Control/Status Registers are summarized in
accessed by either Word (16-bit) or Byte operations.
Table 93. ESPI Registers
The ESPI module includes many enhancements when compared to the simpler SPI module
in other Z8 Encore!
and the SPI module as follows:
•
•
•
•
•
•
Word Address
XXXXX0
XXXXX2
XXXXX4
XXXXX6
Transmit and receive data buffer register added to support higher performance.
Multiple interrupt sources (transmit data, receive data, errors). SPI module only has
data transfer complete interrupt.
DMA controller interface (separate transmit and receive interfaces).
Register addresses redefined to facilitate 16-bit transfers on the ZNEO
Transmit data command register – new register to facilitate DMA interface and
Control register:
– IRQE changed to DIRQE. This allows data interrupts to be disabled when using
– STR bit on the SPI module replaced with ESPIEN1. SPIEN replaced with
– BIRQ replaced with BRGCTL.
improve performance with 16-bit transfers. SSV and TEOF is set on same cycle on
which the data register is written.
DMA but still allow error interrupts.
ESPIEN0. This enhancement allows unidirectional transfers which minimizes
software or DMA overhead.
®
parts. This section highlights the differences between the ESPI module
Even Address
Data
Control
Status
Baud Rate High
P R E L I M I N A R Y
Odd Address
Transmit Data Command
Mode
State
Baud Rate Low
Enhanced Serial Peripheral Interface
Table
93. These registers are
Product Specification
ZNEO
®
Z16F Series.
Z16F Series
178