Z16F2800100ZCOG Zilog, Z16F2800100ZCOG Datasheet - Page 73

• Manufacturer Part Number: Z16F2800100ZCOG
• Description: DEV KIT FOR Z16F ZNEO
• Manufacturer: Zilog
• Series: ZNEO™r
• Type: MCUr

Specifications of Z16F2800100ZCOG

• Contents: Evaluation Board, Software and Documentation
• For Use With/related Products: Z16F Series
• For Use With: 269-4661 - KIT ACC ETHERNET SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4537

Reset and Stop Mode Recovery
Reset Types
Table 18. Reset and Stop Mode Recovery Characteristics and Latency
PS022008-0810
Reset Type
System Reset
Stop Mode
Recovery
The reset controller within the ZNEO
Recovery operation.
In a typical operation, the following events causes a Reset to occur:
•
•
•
•
•
•
When ZNEO Z16F Series is in STOP mode, a Stop Mode Recovery is initiated by either
of the following:
•
•
The ZNEO Z16F Series provides two different types of Reset operation (System Reset and
Stop Mode Recovery). The type of Reset is a function of both the current operating mode
of the ZNEO Z16F Series device and the source of the Reset.
Reset and their operating characteristics.
Power-On Reset.
Voltage Brownout.
WDT time-out (when configured through the
External RESET pin assertion.
OCD initiated Reset (
Fault detect logic.
WDT time-out.
GPIO port input pin transition on an enabled Stop Mode Recovery source.
Reset Characteristics and Latency
Peripheral
Control Registers
Reset (as applicable)
Unaffected, except
RSTSRC and OSCCTL
registers
OCDCTL[0]
P R E L I M I N A R Y
ZNEO CPU
Reset
Reset
®
set to 1).
Z16F Series controls RESET and Stop Mode
WDT_RES
Reset Latency (Delay)
A minimum of 66 internal precision
oscillator cycles.
A minimum of 66 internal precision
oscillator cycles.
Reset and Stop Mode Recovery
option bit to initiate a Reset).
Table 18
Product Specification
ZNEO
lists the types of
Z16F Series
58