mpc823rg Freescale Semiconductor, Inc, mpc823rg Datasheet - Page 921

• Manufacturer Part Number: mpc823rg
• Description: Mpc823 Powerquicc Integrated Communications Processor For Portable Systems
• Manufacturer: Freescale Semiconductor, Inc

W—Wrap (Final Buffer Descriptor in Table)
I—Interrupt
L—Last
S—Transmit Start Condition
When this bit is set to 1, the I
the buffer. If this buffer descriptor is the first one in the frame, a start condition is transmitted,
regardless of the value of this bit. This bit provides the ability to transmit a start byte or
back-to-back frames.
NAK—No Acknowledge
This bit indicates that the transmission has been aborted because the last transmitted byte
was not acknowledged. The I
associated data buffer.
UN—Underrun
This bit indicates that the I
while transmitting the associated data buffer. The I
transmitting the associated data buffer.
CL—Collision
This bit indicates that transmission has been aborted because the transmitter was lost while
arbitrating for the bus. The I
associated data buffer.
0 = This is not the last buffer descriptor in the TX buffer descriptor table.
1 = This is the last buffer descriptor in the TX buffer descriptor table. After this buffer is
0 = No interrupt is generated after this buffer is serviced.
1 = The TXB or TXE bit in the I
0 = This buffer does not contain the last character of the message.
1 = This buffer contains the last character of the message.
0 = A start condition is not transmitted before the first byte of the buffer, unless it is the
1 = A start condition is transmitted before the first byte of the buffer.
used, the communication processor module receives incoming data into the first
buffer descriptor that TBASE points to in the table. The number of TX buffer
descriptors in this table is programmable and determined only by the W bit and
overall space constraints of the dual-port RAM.
and TXE can cause interrupts if they are enabled.
first byte of a frame.
Freescale Semiconductor, Inc.
For More Information On This Product,
2
C controller has encountered a transmitter underrun condition
2
C controller writes this bit after it finishes transmitting the
2
2
C controller transmits a start condition before the first byte of
C controller writes this bit after it finishes transmitting the
MPC823 REFERENCE MANUAL
Go to: www.freescale.com
2
C event register is set when this buffer is serviced. TXB
2
C controller writes this bit after it finishes
Communication Processor Module
16-469