h8s-2628 Renesas Electronics Corporation., h8s-2628 Datasheet - Page 133

• Manufacturer Part Number: h8s-2628
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

6.4
6.4.1
PBC operation can be disabled or enabled using the module stop control register. The initial
setting is for PBC operation to be halted. Register access is enabled by clearing module stop
mode. For details, refer to section 21, Power-Down Modes.
6.4.2
The PC break interrupt is shared by channels A and B. The channel from which the request was
issued must be determined by the interrupt handler.
6.4.3
The CMFA and CMFB flags are not automatically cleared to 0, so 0 must be written to CMFA or
CMFB after first reading the flag while it is set to 1. If the flag is left set to 1, another interrupt
will be requested after interrupt handling ends.
6.4.4
A PC break interrupt generated when the DTC is the bus master is accepted after the bus
mastership has been transferred to the CPU by the bus controller.
6.4.5
Even if the instruction at the address following a BSR, JSR, JMP, TRAPA, RTE, or RTS
instruction is fetched, it is not executed, and so a PC break interrupt is not generated by the
instruction fetch at the next address.
6.4.6
When the I bit is set by an LDC, ANDC, ORC, or XORC instruction, a PC break interrupt
becomes valid two states after the end of the instruction execution. If a PC break interrupt is set
for the instruction following one of these instructions, since interrupts, including NMI, are
disabled for a 3-state period in the case of LDC, ANDC, ORC, and XOR, the next instruction is
always executed. For details, see section 5, Interrupt Controller.
Usage Notes
I Bit Set by LDC, ANDC, ORC, or XORC Instruction
Module Stop Mode Setting
PC Break Interrupts
CMFA and CMFB
PC Break Interrupt when DTC Is Bus Master
PC Break Set for Instruction Fetch at Address Following BSR, JSR, JMP, TRAPA,
RTE, or RTS Instruction
Rev. 3.00 Oct 04, 2005 page 93 of 598
Section 6 PC Break Controller (PBC)
REJ09B0155-0300