h8s-2628 Renesas Electronics Corporation., h8s-2628 Datasheet - Page 404

• Manufacturer Part Number: h8s-2628
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

Section 14 Serial Communication Interface (SCI)
14.7.7
Data reception in Smart Card interface mode uses the same operation procedure as for normal
serial communication interface mode. Figure 14.29 illustrates the retransfer operation when the
SCI is in receive mode.
1. If an error is found when the received parity bit is checked, the PER bit in SSR is
2. The RDRF bit in SSR is not set for a frame in which an error has occurred.
3. If no error is found when the received parity bit is checked, the PER bit in SSR is not set to 1,
Figure 14.30 shows a flowchart for reception. A sequence of receive operations can be performed
automatically by specifying the DTC to be activated using an RXI interrupt source. In a receive
operation, an RXI interrupt request is generated when the RDRF flag is set to 1 if the RIE bit is set
to 1. If the RXI request is designated beforehand as a DTC activation source, the DTC will be
activated by the RXI request, and the receive data will be transferred. The RDRF flag is cleared to
0 automatically when data is transferred by the DTC. If an error occurs in receive mode and the
ORER or PER flag is set to 1, a transfer error interrupt (ERI) request will be generated. Hence, so
the error flag must be cleared to 0. In the event of an error, the DTC is not activated and receive
data is skipped. Therefore, receive data is transferred for only the specified number of bytes in the
event of an error. Even when a parity error occurs in receive mode and the PER flag is set to 1, the
data that has been received is transferred to RDR and can be read from there.
Note: For details on receive operations in block transfer mode, refer to 14.4, Operation in
Rev. 3.00 Oct 04, 2005 page 364 of 598
REJ09B0155-0300
automatically set to 1. If the RIE bit in SCR is set at this time, an ERI interrupt request is
generated. The PER bit in SSR should be kept cleared to 0 until the next parity bit is sampled.
the receive operation is judged to have been completed normally, and the RDRF flag in SSR is
automatically set to 1. If the RIE bit in SCR is enabled at this time, an RXI interrupt request is
generated.
Asynchronous Mode.
RDRF
PER
Serial Data Reception (Except for Block Transfer Mode)
Ds
D0 D1 D2 D3 D4 D5 D6 D7 Dp DE
Figure 14.29 Retransfer Operation in SCI Receive Mode
nth transfer frame
[2]
[1]
Ds D0 D1 D2 D3 D4 D5 D6 D7 Dp
Retransferred frame
(DE)
[4]
[3]
Ds D0 D1 D2 D3 D4
Transfer
frame n+1