h8s-2628 Renesas Electronics Corporation., h8s-2628 Datasheet - Page 146

no-image

h8s-2628

Manufacturer Part Number
h8s-2628
Description
Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
Manufacturer
Renesas Electronics Corporation.
Datasheet
Section 8 Data Transfer Controller (DTC)
In repeat mode or block transfer mode, the CRA is divided into two parts; the upper 8 bits
(CRAH) and the lower 8 bits (CRAL). CRAH holds the number of transfers while CRAL
functions as an 8-bit transfer counter (1 to 256). CRAL is decremented by 1 every time data is
transferred, and the contents of CRAH are sent when the count reaches H'00.
8.2.6
CRB is a 16-bit register that designates the number of times data is to be transferred by the DTC in
block transfer mode. It functions as a 16-bit transfer counter (1 to 65,536) that is decremented by 1
every time data is transferred, and transfer ends when the count reaches H'0000.
8.2.7
DTCER is comprised of seven registers; DTCERA to DTCERG, and is a register that specifies
DTC activation interrupt sources. The correspondence between interrupt sources and DTCE bits is
shown in table 8.1. For DTCE bit setting, use bit manipulation instructions such as BSET and
BCLR for reading and writing. If all interrupts are masked, multiple activation sources can be set
at one time (only at the initial setting) by writing data after executing a dummy read on the
relevant register.
Rev. 3.00 Oct 04, 2005 page 106 of 598
REJ09B0155-0300
Bit
7
6
5
4
3
2
1
0
Bit Name
DTCE7
DTCE6
DTCE5
DTCE4
DTCE3
DTCE2
DTCE1
DTCE0
DTC Transfer Count Register B (CRB)
DTC Enable Registers (DTCER)
Initial Value
0
0
0
0
0
0
0
0
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
DTC Activation Enable
Setting these bits to 1 specifies a relevant interrupt
source as a DTC activation source.
[Clearing conditions]
These bits are not cleared when the DISEL bit is 0
and the specified number of transfers have not been
completed.
Description
When the DISEL bit in MRB is 1 and the data
transfer has ended
When the specified number of transfers have
ended

Related parts for h8s-2628