h8s-2628 Renesas Electronics Corporation., h8s-2628 Datasheet - Page 149

• Manufacturer Part Number: h8s-2628
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

8.4
Locate the register information in the on-chip RAM (addresses: H'FFEBC0 to H'FFEFBF).
Register information should be located at an address that is a multiple of four within the range.
Locating the register information in address space is shown in figure 8.3. Locate the MRA, SAR,
MRB, DAR, CRA, and CRB registers, in that order, from the start address of the register
information.
In the case of chain transfer, register information should be located in consecutive areas and the
register information start address should be located at the vector address corresponding to the
interrupt source as shown in figure 8.3. The DTC reads the start address of the register information
from the vector address set for each activation source, and then reads the register information from
that start address.
When the DTC is activated by software, the vector address is obtained from: H'0400 +
(DTVECR[6:0] 2). For example, if DTVECR is H'10, the vector address is H'0420. The
configuration of the vector address is the same in both normal and advanced modes, a 2-byte unit
being used in both cases. These two bytes specify the lower bits of the register information start
address.
Register
information
start address
Chain
transfer
Location of Register Information and DTC Vector Table
Figure 8.3 Location of DTC Register Information in Address Space
MRA
MRA
MRB
MRB
0
CRA
CRA
Lower address
1
4 bytes
DAR
DAR
SAR
SAR
2
CRB
CRB
Section 8 Data Transfer Controller (DTC)
Rev. 3.00 Oct 04, 2005 page 109 of 598
3
Register information
Register information
for 2nd transfer in
chain transfer
REJ09B0155-0300