h8s-2628 Renesas Electronics Corporation., h8s-2628 Datasheet - Page 499

• Manufacturer Part Number: h8s-2628
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

17.4.4
A/D conversion can be externally triggered. When bits TRGS0 and TRGS1 in ADCR are set to
11, an external trigger is input on the
ADST bit in ADCSR is set to 1, and the A/D conversion starts. Other operations are the same as
when the ADST bit has been set to 1 by software in both single and scan modes. Figure 17.3
shows the timing.
17.5
When A/D conversion is completed, the A/D converter generates an A/D conversion end interrupt
(ADI). The ADI interrupt request is enabled when the ADIE bit is set to 1 while the ADF bit in
ADCSR is set to 1 after A/D conversion is completed. The DTC can be activated by an ADI
interrupt. Having the converted data read by the DTC in response to an ADI interrupt enables
continuous conversion without imposing a load on software.
Table 17.5 A/D Converter Interrupt Source
Name
ADI
ADTRG
Internal trigger signal
ADST
External Trigger Input Timing
Interrupt Source
Interrupt Source
A/D conversion completed
Figure 17.3 External Trigger Input Timing
A D T R G
pin. At the falling edge of the
Interrupt Source Flag
ADF
Rev. 3.00 Oct 04, 2005 page 459 of 598
A/D conversion
Section 17 A/D Converter
A D T R G
DTC Activation
Possible
REJ09B0155-0300
pin, the