h8s-2628 Renesas Electronics Corporation., h8s-2628 Datasheet - Page 281

• Manufacturer Part Number: h8s-2628
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2600 Series
• Manufacturer: Renesas Electronics Corporation.

10.9
10.9.1
TPU operation can be disabled or enabled using the module stop control register. The initial
setting is for TPU operation to be halted. Register access is enabled by clearing module stop
mode. For details, refer to section 21, Power-Down Modes.
10.9.2
The input clock pulse width must be at least 1.5 states in the case of single-edge detection, and at
least 2.5 states in the case of both-edge detection. The TPU will not operate properly at narrower
pulse widths.
In phase counting mode, the phase difference and overlap between the two input clocks must be at
least 1.5 states, and the pulse width must be at least 2.5 states. Figure 10.44 shows the input clock
conditions in phase counting mode.
Figure 10.44 Phase Difference, Overlap, and Pulse Width in Phase Counting Mode
TCLKA
(TCLKC)
TCLKB
(TCLKD)
Notes: Phase difference and overlap
Usage Notes
Module Stop Mode Setting
Input Clock Restrictions
Pulse width
Overlap
Pulse width
Phase
differ-
ence
Overlap
: 1.5 states or more
: 2.5 states or more
Phase
differ-
ence
Pulse width
Section 10 16-Bit Timer Pulse Unit (TPU)
Rev. 3.00 Oct 04, 2005 page 241 of 598
Pulse width
Pulse width
REJ09B0155-0300