UPD70F3786GJ-GAE-AX Renesas Electronics America, UPD70F3786GJ-GAE-AX Datasheet - Page 1661

• Manufacturer Part Number: UPD70F3786GJ-GAE-AX
• Description: MCU 32BIT V850ES/JX3-E 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Er

Specifications of UPD70F3786GJ-GAE-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, CSI, EBI/EMI, Ethernet, I²C, UART/USART, USB
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 100
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 124K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

and program command prohibit functions are enabled by default after shipment, and security can be set by rewriting
via on-board/off-board programming. Each security function can be used in combination with the others at the same
time.
Block erasure
Chip erasure
Write
Verify/checksum
Blank check
Security setting
Block erase command prohibit
Chip erase command prohibit
Program command prohibit
Read command prohibit
Boot area rewrite prohibit
The following table lists the security functions. The block erase command prohibit, chip erase command prohibit,
Function
Function
The contents of specified memory blocks
are erased.
The contents of the entire memory area
are erased all at once.
Writing to specified addresses, and a
verify check to see if write level is secured
are performed.
Data read from the flash memory is
compared with data transferred from the
flash programmer.
The erasure status of the entire memory is
checked.
Use of the block erase command, chip
erase command, program command, and
read command is prohibited, and rewriting
of the boot area is prohibited.
Functional Outline
Execution of a block erase command on all blocks is prohibited. Setting of prohibition can be
initialized by execution of a chip erase command.
Execution of block erase and chip erase commands on all the blocks is prohibited. Once
prohibition is set, setting of prohibition cannot be initialized because the chip erase command
cannot be executed.
Execution of program and block erase commands on all the blocks is prohibited. Setting of
prohibition can be initialized by execution of the chip erase command.
Execution of a read command on all of the blocks is prohibited. Setting of the prohibition can be
initialized by execution of a chip erase command.
Execution of write, block erase, and chip erase commands on the boot area is prohibited.
Setting of the prohibition of rewriting the boot area cannot be initialized after it is once set.
Table 33-3. Security Functions
CHAPTER 33 FLASH MEMORY
Table 33-2. Basic Functions
User’s Manual U19601EJ2V0UD
On-Board/Off-Board
Function Outline
Programming
Support (√: Supported, ×: Not supported)
√
√
√
√
√
√
(Supported only when setting
is changed from enable to
(Can be read by user
Self Programming
program)
disable)
√
×
√
×
√
×
1659