UPD70F3786GJ-GAE-AX Renesas Electronics America, UPD70F3786GJ-GAE-AX Datasheet - Page 226

• Manufacturer Part Number: UPD70F3786GJ-GAE-AX
• Description: MCU 32BIT V850ES/JX3-E 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Er

Specifications of UPD70F3786GJ-GAE-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, CSI, EBI/EMI, Ethernet, I²C, UART/USART, USB
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 100
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 124K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

224
(a) Example of setting main clock operation → subclock operation
<1> CK3 bit ← 1:
<2> Subclock operation: Read the CLS bit to check if subclock operation has started. It takes the
<3> MCK bit ← 1:
Cautions 1. When stopping the main clock, stop the PLL. Also stop the operations of the on-chip
Remark Internal system clock (f
[Description example]
<1> _SET_SUB_RUN :
<2> _CHECK_CLS :
<3> _STOP_MAIN_CLOCK :
Remark The description above is simply an example. Note that in <2> above, the CLS bit is read in a
_DMA_DISABLE:
clrl
st.b
set1
tst1
bz
st.b
set1
_DMA_ENABLE:
setl
2. If the following conditions are not satisfied, change the CK2 to CK0 bits so that the
closed loop.
peripheral functions operating with the main clock.
conditions are satisfied, then change to the subclock operation mode.
Internal system clock (f
0, DCHCn[r0]
r0, PRCMD[r0]
3, PCC[r0]
4, PCC[r0]
_CHECK_CLS
r0, PRCMD[r0]
6, PCC[r0]
0, DCHCn[r0]
CHAPTER 6 CLOCK GENERATION FUNCTION
Use of a bit manipulation instruction is recommended. Do not change the CK2
to CK0 bits.
following time after the CK3 bit is set until subclock operation is started.
Set the MCK bit to 1 only when stopping the main clock.
Max.: 1/f
CLK
User’s Manual U19601EJ2V0UD
): Clock generated from the main clock (f
CK0 bits
XT
(1/subclock frequency)
CLK
) > Subclock (f
-- DMA operation disabled. n = 0 to 3
-- CK3 bit ← 1
-- Wait until subclock operation starts.
-- MCK bit ← 1, main clock is stopped.
-- DMA operation enabled. n = 0 to 3
XT
: 32.768 kHz) × 4
XX
) by setting the CK2 to